Electronics Forum | Mon May 09 09:23:45 EDT 2016 | markhoch
I agree with the previous two replies. This is a perfect design....if you're trying to create a graveyard full of tombstones.
Electronics Forum | Fri Apr 18 14:25:51 EDT 2014 | horchak
what is the technology? Is there fine pitch, double sided, number of layers, lead free? If the pcbs are not of the highest quality you may be set up for failure with no clean process. Couple things to look at is your paste flux content versus medal
Electronics Forum | Wed Jun 23 15:49:30 EDT 1999 | Kelly Morris
In the IPC-SM-782 (Surface Mount Design and Land Pattern Standard) it recommends a minimum of .040" between bottomside wavesoldered chip pads. Where might I find a similar IPC recommendation for minimum space between thru-hole pads? Does anyone kno
Electronics Forum | Fri Dec 10 08:42:37 EST 2004 | mattkehoe
We had some bad experiences trying to work with soldermask defined BGA pads. If the opening in the soldermask is right to the edge of the copper/pad without a space it can leave reside on the pad and nothing will stick to it. See http://www.sipad.com
Electronics Forum | Thu Dec 09 07:46:42 EST 2004 | davef
We did this for BGA pads, but have not thought about other types. So, this may or may not apply for those. Pad defined by:||Advantages||Disadvantages Non-solder mask||No point-of-stress concentration at edge mask and solder ball||Smaller pads have
Electronics Forum | Thu Mar 15 09:28:19 EDT 2007 | jseagle
I have seen this when the fiducials are not spaced far enough in the X and Y.
Electronics Forum | Thu Nov 30 16:14:33 EST 2006 | darby
Maybe ask your customer where they got this idea from? It is possible they may have even got this idea from some white paper or article where they are trying to explain something else and show drawings with no solder between the pad and lead. It may
Electronics Forum | Tue Nov 28 09:21:58 EST 2006 | Michael Sanders
Is anyone aware of any articles, white papers, etc., that discuss the gap between the lead and the pad after a SM joint is soldered? In particular, I am looking for a formula for that "gap" for various components.
Electronics Forum | Tue Nov 28 09:37:39 EST 2006 | GS
Have you seen IPC-A-610 D ? regards GS
Electronics Forum | Tue Nov 28 15:41:51 EST 2006 | realchunks
Try IPC-SM-782.