Electronics Forum | Mon Apr 24 19:18:40 EDT 2006 | sessioc
OK guys here is the skinny..... > > We need an > oven that can handle lead free temps without > slowing the belt speed under 28 or so in. per > min. > > BTU tells me that they don't recommend an > oven that maxes any less than 350 C. > > Is an
Electronics Forum | Wed Feb 21 17:27:02 EST 2001 | jollyrodger
HELP...... I have recently taken on the post of line technician at my place of work. I require as much information as you can give me on all SMT processes. We work with Fuji CP643E, Philips FCM, Dek 265, Universal GSM, BTU Paragon ovens. All infor
Electronics Forum | Tue Sep 16 10:14:03 EDT 2003 | mantis
James, Could it be the convection in the reflow oven itself.Maybe somebody has increased the air flow or convection rate. I have seen an issue with an sot23 blowing off pad in a BTU paragon due to air flow in air curtains being too high. Hope this h
Electronics Forum | Thu Sep 15 13:52:40 EDT 2005 | pr
We had 2 at my last company. As I recall we had a hell of a time with bad blower motors. I'm not sure how you'd check on that, but maybe that problem has been fixed by now (it's been a few years). good luck, pr
Electronics Forum | Wed Apr 21 14:32:52 EDT 2010 | remullis
These ovens maintain good profiling as long as you stay on top of maintenance. I had 4 150's and 1 125. The biggest headache is keep the plenums cleaned (very messy). Also the blower motors have been replaced a few times on them as well. If I were yo
Electronics Forum | Sun Apr 23 09:04:36 EDT 2006 | kanna
Does anyone have any experience with these ovens > ? We are looking at purchasing a used > one. Anything in particular I should look at > when inspecting it ? > > Any comments good or bad > appreciated..... > > Thnx, Sr. i have one problem he
Electronics Forum | Thu Apr 27 04:52:06 EDT 2006 | slaine
Ive a 5 zone vip 90, running at temperatures up to 280 degrees, biggest problem we have is with the fan moters siezing up. think we must have changed 8 out of 10 of them ok there 10 years old but it can be a lot of hastle. they sieze absolutly solid.
Electronics Forum | Fri Oct 01 04:31:08 EDT 2004 | pioneertechnology
Hi Marcel I bought four BTU ovens a couple of years ago at auction and had the same problem where two of the ovens had software and two did not. I loaded in the software I had onto the two ovens and this only partially worked as the software is con
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Sat Dec 10 22:31:16 EST 2016 | ecogroup
Hi Tom, We have a Paragon 150 with the FCU board problem. We are thinking about finding another board and swapping it . Did you get the ROM chips from BTU when you swapped the FCU board? Appreciate any advice. Thank you. Ray