Electronics Forum | Tue Dec 04 15:18:31 EST 2007 | davef
Real Chunks: Do you think a 28-pin connector is too large? For us, it's all about the number of rows. One or two rows are no big whoop. Three rows and greater, now that's when it gets messier.
Electronics Forum | Thu Dec 24 06:43:08 EST 2015 | sarason
What piece of equipment did it come out of?
Electronics Forum | Mon Dec 28 10:38:51 EST 2015 | emeto
Just download datasheet for the manufacturer part number(if you have it). If you don't, it will be hard - it might be 1,2,3, or 4 symbols from this label that matter. Marking might be RAF, might be FE as well.You can see all possibilities here.
Electronics Forum | Tue Feb 24 16:11:15 EST 2015 | emeto
I assume you have a part number system. If so, you should kit the reel with less parts first from the same part number. If you don't use part number system, then you probably have components sorted by value and size, which should lead to the same pri
Electronics Forum | Wed Dec 05 07:25:22 EST 2007 | realchunks
All posters here are right. My point was you have to design your board to the process. You cannot simply take any connector and change it to Pin and Paste. So much depends on your aperture openings, hole size to pin size, board thickness, number o
Electronics Forum | Fri Dec 27 07:20:38 EST 2019 | dipak123
We have Mirtec MV-6 OMNI machine. If programer changes in part number ,then that part x-out from it's place.Value of X & Y incresed 10X compare to other parts in ATT.
Electronics Forum | Fri Jan 16 04:04:59 EST 2015 | philc
This looks like it might be a Fairchild part. Try emailing them with the marking, and see what they say.
Electronics Forum | Wed Dec 23 10:29:08 EST 2015 | eniac
I'm not sure, but may be it can help: SSTA29 from ROHM has a marking RAF - http://www.datasheetarchive.com/dlmain/Datasheets-115/DSAP001800.pdf Hope, it can be a start of your searching.
Electronics Forum | Wed Jan 09 10:46:17 EST 2019 | rvines1
I've recently seen some TO-220 FETs that appear to be counterfeit parts that have had the marked area resurfaced and remarked with a false part number. I don't know much about semiconductor manufacturing, and I just want to know if there is a type o
Electronics Forum | Thu Oct 14 18:17:34 EDT 1999 | JAX
Larry, What's happening. You can get this information from the manufacturer. All you need is the manufacturing part number. You should be able to get this from the purchasing department. Once you have this info just open up their website and fo
