Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl
Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a
Electronics Forum | Wed Oct 23 13:01:11 EDT 2019 | compit
I have a single-view camera on a Topaz-X machine. When I define a connector type element - it displays messages like in attached files. If I change the type to IC - no problem. There is also no problem when "learning&quot
Electronics Forum | Mon Oct 24 05:43:52 EDT 2016 | zxcvb
I have many PCBs that use an AVR in SMD packaging, and since I frequently change the firmware in prototype boards, I'm trying to come with the best solution to program the AVR quickly and easily. The first approach was to have a standard header (2x5
Electronics Forum | Sat Nov 09 20:11:43 EST 2019 | richardcargill
I suspect configuration too. From memory, only certain heads are assignable as 'Fine'. Changing this parameter in the component data to Standard or QFP will most likely cure this as any head will accept those two options
Electronics Forum | Thu Dec 07 11:49:28 EST 2006 | K
We currently have RMA and WS soldering processes here and do batch cleaning for both. We are experiencing some capacity issues and are interested in looking at an IN-LINE aqueous wash. My experience with in-line wash is only with WS. 1. Since RMAs
Electronics Forum | Thu Dec 08 12:39:39 EST 2016 | deanm
We have a name brand aqueous batch cleaner that uses a chemical and DI water to clean ROL0 flux from our PCBs. It does ok most of the time for SMT boards and we want to include through hole assemblies as well which should be a better cleaning process
Electronics Forum | Thu Nov 17 03:34:51 EST 2005 | cangly
Hi, We have a board with over 100 chips (mixed size) and some long Connector DIP through out Wave solder with many issues of no solder and solder bridge, (using clean flux with bubble fluxer and Kester solder bar). Currently we tried to reduce the de
Electronics Forum | Wed Jul 20 22:59:34 EDT 2016 | ttheis
I had something similar to this on a different type of machine but it turned out to be a broken wire terminal connector at the switch causing intermittent connection. Often with safety circuits they are kept high and brought low or interrupted to dis
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower