Electronics Forum | Tue Jan 28 10:36:39 EST 2014 | cbeneat
Have you tried 4530, again for the X5's this is our operator password. Good luck
Electronics Forum | Thu Dec 10 13:53:06 EST 2015 | ttheis
Hi David, I posted the password a while back; I believe it is F1-left-down-right if I recall correctly.
Electronics Forum | Wed Oct 26 12:58:14 EDT 2022 | proceng1
Click the Sys Setup tab, start typing markfac Then a box pops up. password is markfactory Gives extra menus, but don't mess too much around in there if you don't know what they do.
Electronics Forum | Thu May 11 14:54:34 EDT 2023 | babe7362000
Does anyone know if there was a common password used for the Simplimatic unloader? Its a 4 digit pin number, and unfortunately we bought the machine used and can not locate it. Any information would be greatly appreciated.
Electronics Forum | Wed Oct 28 19:48:33 EDT 2009 | lgroves
Hi, The machine is a Samsung CP45FV-Neo. Is > there a way to set the level of control operators > have over a program? We'd like to have a program > which can't be changed, except by a technician. I > can't see any way of doing this with the mach
Electronics Forum | Wed Jun 04 04:57:38 EDT 2003 | emeto
Hi Why don't you just call them? Is it forbidden to config the machine?
Electronics Forum | Tue Nov 25 18:30:36 EST 2003 | bman
I think it might just be zcr. At least that is what it is for our oven.
Electronics Forum | Wed Nov 26 11:36:36 EST 2003 | equipres
I remember it being case sensitive. Did you try that?
Electronics Forum | Mon Mar 28 10:51:44 EST 2005 | deano
To get into the program type: oven To change things type: quad