Electronics Forum | Mon Apr 21 06:26:28 EDT 2003 | Grant
Hi, We have a SMT production like, however we have very little experience with through hole assembly. We design everything to be completly SMT based, however connectors are the only part of our product that still requires through hole assembly. Cur
Electronics Forum | Mon May 01 23:23:58 EDT 2006 | grantp
Hi, I off center idea we used when we started. Get a pasta cooker, and put in vapor phase fluid, and then use that. Place the product in the bottom of the inner pot, and then heat on a small hot plate. When the vapor cloud gets high enough and the
Electronics Forum | Fri Apr 08 16:26:36 EDT 2005 | Grant
Hi, It seems weird that an automated pick and place machine at a board shop would not be up to NASA standards, but placing the components by hand would be. However most SMT will self center a bit, so if your close enough, you should be ok. You rea
Electronics Forum | Wed Dec 05 03:33:22 EST 2007 | longlee
We have done Paste-In-Hole process for 4 years.I think this prcess is suitable for 28-pins connector. Of course, you must assure the connecotr can endure high temperature firstly.Secondly, you need calculate the volume of solder paste, you can refere
Electronics Forum | Sat Jun 12 00:34:00 EDT 2004 | kanwal324
Hi ! The main problem being faced currently is formation of solder balls - to be precise, these are micro solder beads generally found attached with bodies of SOTs, Chip Caps, Chip Resistors, between pins of SOICs (50 mil) - lying on PCB surface,
Electronics Forum | Wed Jul 05 01:22:29 EDT 2006 | grantp
Hi, When I started out and we were the same we got an old MYDATA TP9-2U. It places everything, and you should be able to get a cheap one second hand, that will perform very well. They have vision as well, as an options, and that works very well. I w
Electronics Forum | Mon Nov 06 14:00:45 EST 2006 | nodlac
Checks calendar ...nope not April 1st. -The fresher the paste the better the solder joint. Agreed - My dilema here is upper management wants the two lines to share one stencil printer thus saving the cost of purchasing a second printer. They propos
Electronics Forum | Thu Oct 04 00:10:15 EDT 2018 | gaintstar
flason smt wave soldering machine: http://www.flason-smt.com/product/SMT-stencil-printer-Dek-Y-Axis-Motor-133128.html http://www.flason-smt.com/product/SMT-stencil-printer-spare-parts-Dek-Camera-181054.html http://www.flason-smt.com/product/SMT-stenc
Electronics Forum | Wed Oct 03 23:59:44 EDT 2018 | gaintstar
Flason SMT problem solving: http://www.flason-smt.com/new/PRINCIPLE-OF-SURFACE-MOUNT-PROCESS-SMT-PROCESS.html http://www.flason-smt.com/new/Printed-Circuit-Board-PCB-Price-Estimator.html http://www.flason-smt.com/new/Printed-Circuit-Board-Solder-res
Electronics Forum | Thu Oct 04 00:05:25 EDT 2018 | gaintstar
Flason SMT chip mounter Reflow Ovens: http://www.flason-smt.com/product/PCB-assembly-line-equipment-SMT-spare-parts-Dek-Motor-188962.html http://www.flason-smt.com/product/PCB-Conveyor-for-LED-Production-Line-SMT-Assembly-Line.html http://www.flason-