Electronics Forum | Wed Mar 11 18:28:03 EDT 2015 | gregoryyork
Hi its undercured solder resist which leaves a clear waxy/oily residue and can be seen as brown tar/oil in the molten solder wave. This also causes MicroSolder Balling and some snail trails of solder pick up and worst case bridging and peeling resist
Electronics Forum | Tue May 10 15:27:36 EDT 2005 | amejia
We actually did try dots, 1/8" to be exact. We found that they were hard to peel off using just your fingers. Also, the manufacturer punched the dots too deep and ended up going through the backing on many of them. However, using tweezers, it didn
Electronics Forum | Fri Jan 15 15:06:30 EST 1999 | Earl Moon
| Hello, | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | So far, the tests I can think of performing, and that we have
Electronics Forum | Fri Jan 15 15:17:21 EST 1999 | Earl Moon
| | Hello, | | | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | | | So far, the tests I can think of performing, and tha
Electronics Forum | Mon Oct 23 06:51:36 EDT 2000 | fastech6
I have a problem with solder getting into exposed gold pads. What is the best rework procedure for removing the solder and restoring the gold condition of the pad? At the moment, we are also covering the gold pad with kapton tape prior to solder
Electronics Forum | Fri Jan 15 16:55:50 EST 1999 | Chrys
| | | Hello, | | | | | | We are qualifying new sources of PWB vendors. We've got the first lot of "produciton" boards in and we want to put them through the paces before turing the vendors on. | | | | | | So far, the tests I can think of performin
Electronics Forum | Sat Apr 21 08:26:57 EDT 2007 | Cmiller
Has anyone experienced a problem with conformal coating adhesion to IS-410 boards? We are having problems with one suppliers boards. IS-410 boards from other suppliers are fine and all FR-4 boards that I have looked at are fine. We are using Conap
Electronics Forum | Mon Oct 11 08:34:52 EDT 1999 | C.K.
Thanks for the acvice, Dave and John. Like I stated above, I didn't feel comfortable with changing wave parameters since I knew that we'd be compromising our wave quality. I'll try the peelable mask thing, reprofile, and let you guys know what i fo
Electronics Forum | Thu May 07 13:22:37 EDT 1998 | Chrys
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Fri Oct 09 14:35:58 EDT 1998 | Chrys
| Does anyone out there have hands on experience of selective soldering. Either masking or miniwave type. I am looking for pointers with regard to equipment selection and known process problems/ limitations | Charles, I've used both miniwave and s
