Electronics Forum | Mon Jan 27 10:37:14 EST 2020 | jede
In what regards? If you are wondering if the gridlock will cause damage to parts on the underside of the board, the concern is using fixed support rails. A company I used to work for fixed this by using pneumatic support rails(I am sure there are exa
Electronics Forum | Fri Apr 03 07:08:30 EDT 2020 | compit
Asssembleon recommends Molykote 6169 (Yamaha #6169) grease for pneumatic components of heads, but it is no longer available. What do you use instead?
Electronics Forum | Tue Feb 09 21:00:32 EST 2021 | dekhead
Unfortunately, with the Micron ('i') series of machines, DEK seemed to stop making "ProFlow Ready" the standard on machines. In general, there are additional pneumatics and electronics required for a ProFlow installation.
Electronics Forum | Fri Apr 30 07:29:02 EDT 2021 | dilogic
Status output is pin 2. On pneumatic feeders it only shows if the feeder is inserted, on electric feeders it doubles as feeder insertion and goes off if the tape is exhausted or feeder is jammed
Electronics Forum | Wed May 10 17:57:36 EDT 2023 | leviwhite
Bevor ich mit dem Spielen anfangen, komme ich wieder zu einem Beitrag, in dem die neuesten Nachrichten über die Casinowelt vorgestellt sind. Das hilft mir, richtige Entscheidung zu treffen.
Electronics Forum | Fri Nov 30 11:04:23 EST 2007 | slthomas
Sounds like Mydata might be one you could look at, for example. I don't have experience with them but they do have "smart" feeder capability. Some machines use electronically controlled and motor driven feeders, some use pneumatic and/or mechanicall
Electronics Forum | Mon Nov 02 15:29:16 EST 2009 | dilogic
Pneumatic feeders are fixed-pitch, which is quite OK for most 8mm tape parts (except 0402 and smaller). Multipitch feeders are electric and cost a lot more, so you should see what pitches do you need and is it worth buying MP feeder(s). We have 30% i
Electronics Forum | Fri Jan 16 16:35:49 EST 2015 | rgduval
Evtimov, I would love to look at a more contemporary machine! Or, jobs that fit better on the machine that we have. However; a. we're a start up, and the GSM was here before I was; and b. we're a start up, in the EMS world, and sometimes, don't get
Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Mon Mar 05 11:21:50 EST 2018 | spoiltforchoice
Why are they so > expensive? Feeders are expensive, you can easily have considerably more invested in feeders than the placement machine. On new machines you won't find feeders coming in at much less than $500/each, often considerably more. As a r