Electronics Forum | Mon Feb 25 11:35:40 EST 2019 | dekhead
Does camera complete moves (Baord stop, Fiducial Positions) without error in camera diagnostic?
Electronics Forum | Wed Aug 24 05:23:45 EDT 2016 | bukas
hello, DEK wont start and im getting this error message: motor com error, axis 1,2,3 fatal error, reinitialise machine. this happens about 30 sec after BIOSes are copied to shadow ram. euro sys cards are inserted properly and on segment display is s
Electronics Forum | Wed Mar 03 14:25:02 EST 2021 | astarotf
Hi Spoiltforchoice Thanks for the comment. With the line encoder readers that the machine brings, we performed a positioning reading check, which showed us the increase or decrease in the path that the heads make, with which we conclude that it is re
Electronics Forum | Wed May 13 10:34:57 EDT 2015 | squeekypigeon
If memory serves me right, if you are test picking a component which will be served to the machine via an LCS the 'pick position' will automatically set itself to feeder slot 1. If you change this to something more central (I used to use location 4
Electronics Forum | Wed May 13 12:39:25 EDT 2015 | arbpkevin
Ahh, yes. Just about the same time you replied someone else I asked said the same thing! I didn't realize that you had to put the part on by hand for the vision test. In the book it says to leave the feeder position set to the default setting. Fu
Electronics Forum | Wed Jan 19 13:30:37 EST 2011 | bvdb
The user manual says: Cause: A stick feeder part shuttle is in the advanced position where it could interfere with the nozzle. Remedy: Press the [I/O] function key and retract the part shuttle. I don't have a stick feeder. I tried resetting the I
Electronics Forum | Tue Jan 26 05:42:56 EST 2010 | dilogic
Our GSM1 with Flex2 heads started to generate occasional error message: "Axis head 1 theta positive lead error during move absolute command" and then stop. After palm-down it runs again for some time. Everything looks fine, so I have no idea where
Electronics Forum | Thu Jan 22 12:21:54 EST 1998 | Michael Allen
Is there a standard (JEDEC or other) for "lead sweep" errors on fine pitch (eg, 0.5mm) gull wing leads? Parts from one of my suppliers has a sweep error up to 6 mils; the mechanical drawing does not address lead sweep error, nor is there a true posi
Electronics Forum | Thu Feb 04 02:46:39 EST 2010 | dilogic
OK, here we are: 1. OS is OS&2 2. Sw. is USOS V1.14 3. GSM1 4. 2 Flex2 heads 5. Problem is on the front head 6. No 7. No 8. It just stops in the middle of the placement phase, with the head over PCB area. Usually 2 parts are still held on the nozz
Electronics Forum | Thu Aug 22 04:08:17 EDT 2002 | Jason Baldwin
Symptom: Board Stuck on Print Conveyor error messages. Cause: Board not flagging the camera sensor. Remedy: Check the following items: � Check the camera sensor can see the board underneath. � Check the camera sensor calibration (in Tools, Camera Re
