Electronics Forum | Mon Aug 03 07:14:38 EDT 2020 | bangir
Hi, How to adjust the table height of Screen Printing EKRA X5? Could you share me the Manual System Operation?
Electronics Forum | Thu Sep 20 16:51:31 EDT 2001 | jschake
Using an enclosed pressurized printhead system will significantly reduce the waste produced compared to printing glue using squeegees. In trying to stay with the 0201 theme here, I will add that printing glue or adhesive for 0201s continues to be a
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Wed Sep 19 14:23:31 EDT 2001 | jschake
Pad Metallurgy Used: Copper OSP pads were used for all of the results that I have been reporting. The same design test boards with Nickel/Gold pads are available and awaiting further assembly tests. I will consult with a board technology and metall
Electronics Forum | Tue Nov 16 18:10:15 EST 1999 | Richard
Michael, IMP Printed Circuits in Adelaide ( Australia) have an old XY table / Digitiser head system that just needs a Maher controller to get it up and running. Their email is imppcb@codan.com.au attention Bob Armstrong. Regards Richard
Electronics Forum | Mon May 31 09:46:28 EDT 1999 | KEVIN SIMPSON
| We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | Pros: smaller storage requirements and cheaper stencils. | | Cons: sharp metal edges, additional change over time required | | Can anyone relay
Electronics Forum | Fri Jun 04 12:23:04 EDT 1999 | tannlin
| | We are looking into frameless stencil systems for screen printing. Outside frame size of 29x29. | | | | Pros: smaller storage requirements and cheaper stencils. | | | | Cons: sharp metal edges, additional change over time required | | | | Can
Electronics Forum | Sun Mar 12 22:02:40 EST 2006 | Steveo
Personally I think Grid lok is inferior to the new Vacunest system, especially in screen printing. Vacunest is basically a bean bag that conforms to the shape of the PCB and then holds this shape indefinatley under vacuum, until the vacuum is releas
Electronics Forum | Wed Dec 27 23:04:10 EST 2006 | i want to learn from u
Most of pcb have white/black printing at bottom side of them to indicate the chip location. Normally, this printing are the same location to the place that glue will be mount. My problem are the glue size between the point that have printing and not
Electronics Forum | Mon Nov 04 17:29:34 EST 2002 | pjc
Cannot comment on "best buy". You'll have to determine what the better machine is for your application and duration of planned use. I suggest taking a field trip to each vendor's nearest demo facility with a few of your most hi-tech boards and stenci
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400