Electronics Forum | Thu Feb 26 12:58:21 EST 2015 | daniel_esposito
Hi everyone! I have P&P Quad IVc. The Hand Held Terminal (HHT)says "V idle" intead of "V ENTER CMD", and when it is running, the HHT shows commands lines each one at the same time it is running. One of our technician entered mistakenly, at the HHT,
Electronics Forum | Tue Dec 19 11:40:47 EST 2023 | jeana
Hello everyone, We recently got a Quad IVc machine with PPM software on it. We are struggling with 0402, as we get plenty QuadAlign failures. We ticked Vision on failure, so that we limit the amount of rejected parts, but on 0402 Vision system gi
Electronics Forum | Mon Jan 27 10:06:03 EST 2003 | binns
Just to set the record straight... Samsung did not build all Quad machines. QSA = Quad Samsung America, The QSA-30 machine platforms were manufactured by Samsung, utilizing Quad feeders, other Quad technology and Quad sales and service. Before the
Electronics Forum | Thu May 18 11:55:15 EDT 2006 | RLM
Is a Juki feeder a stand alone unit or does it need to communicate with the assembler ? I can operate a Quad feeder just by hooking it up to a proper voltage source. No need to communicate with a computer. If the Juki's will operate this way maybe I
Electronics Forum | Mon Jul 06 06:51:50 EDT 2009 | leemeyer
Many years ago we purchased a IOmega ZIP drive that would connect to the parallel port of the computer. They have a utility called "guest" that we installed on all of the IVC computers. We were then able to connect the drive to the parallel port and
Electronics Forum | Mon Jun 19 23:08:01 EDT 2000 | Hermie
I'm looking for a Remote Camera Box for QUAD C series machines. Quad sells this in a kit (Box and Camera). I just need the Box. Can someone tell me if there's any CO. where I can buy just the Remote Box itself alone?
Electronics Forum | Fri Mar 11 11:19:02 EST 2005 | Steve C.
I would change the Quad Align cable. If you have a spare head board swap that out as well. Make sure your Quad Align lenses are clean. If the camera is smudged then you can have some problems aligning parts as well. Let us know what you find. Cheers.
Electronics Forum | Tue Sep 25 13:03:19 EDT 2012 | saduquette
Thanks bobpan. As we're a real small shop, I'd like to try and repair the board myself. Does anyone know where I can get a set of maintenance/repair manuals for a Quad 4C? At least the schematics for the Quad Align board would help for
Electronics Forum | Fri Nov 20 23:22:52 EST 2015 | rx8pilot
Hello, I am trying to figure out if it is possible to program the index distance on Quad Tyco Feeders. I recently got a Quad IV-C and on the 16mm feeders, they index 12mm where I have an 8mm pitch tape. It is a non-IQ machine so I am looking an man
Electronics Forum | Thu Aug 16 14:29:00 EDT 2012 | bobpan
Sounds to me like a dirty quad-align. If you have cleaned the lens and have the same results then you may have dirt on the inside of the quad-align. The only fix is to replace it or blow it out with an air gun. Unfortunately it is not easy to tell if