Electronics Forum | Mon May 19 15:42:37 EDT 2008 | torch
hey folks, just finished a quick 4 day training course on our 2nd user Quad QSV-1 and will probably have more questions later on but for now can someone confirm that qsoft needs its theta data in + numbers and cannot handle - theta figures? what i m
Electronics Forum | Thu Jun 14 20:54:57 EDT 2012 | deanm
We have a Quad QSV-1 and have had some trouble with it reading 0.040" fiducials. Our work is very low volume so we just manually spot the ones it can't read. We do not clean the fiducials. Instead we increased the fiducial size to 0.060" and it has b
Electronics Forum | Tue Nov 25 08:36:32 EST 2014 | bobpan
Tep stands for the transport card. The board is located in the front bottom left of the machine and should be by itself and have green and red leds lit on the top of it. I would try to reseat the card and then try to reboot the machine. If the proble
Electronics Forum | Mon Jan 20 03:50:37 EST 2020 | falconex_technician
Hi, my company bough second hand pick and place as our second machine. After first transport after start just when initializing, It's showing problem with Z calibration. After second position setup and connect again after month, now showing &
Electronics Forum | Mon Nov 30 21:05:57 EST 1998 | Dave F
| I got Quad QSV-1 assemblier and Tescon Point5588 fly probe tester this year. Any body know what kind software suit best for transfer Cadence Alegro 13 CAD data into those QSV-1 and Point5588 machine ? | There are some software packages like UNICAM
Electronics Forum | Thu Nov 12 00:02:45 EST 1998 | Gang Pan
I have just finished this excise which compared Mydata and Quad machine. As the result I purchased Quad QSV-1 model SMT assembler. In my opinion select which one that will depend on your applications. Also depend on what machines you compare with.
Electronics Forum | Fri Nov 05 11:30:53 EDT 2010 | deanm
We have a Quad QSV-1 pick and place machine that has performed fine for us with the exception of cylindrical glass (MELF) type diodes. The machine often fails to pick these out of the tape to the point where it is easier to hand place them. As far
Electronics Forum | Sun May 11 17:29:17 EDT 2014 | bobpan
Most times when the machine oscillates when closing the doors it will be a problem with the digital i/o cards. I would check that the dip switch settings are correct. If they are correct i would look at replacing both of the cards. The boards are sub
Electronics Forum | Thu Aug 08 11:04:48 EDT 2019 | btfonseca
Hi everyone, I was recently trying to troubleshoot a bad floppy driver on our QSV-1, which actually worked, I was able to read floppy drives but for some reason it all went downhill when one of the green LED's turned off and another red LED turned on
Electronics Forum | Wed Apr 17 05:21:50 EDT 2013 | navbill
Hi, We have QSV-1 machines with stock Quad IQ feeders (8 pins). Some of these feeders will produce a "feeder does not exist" error on both the pick and place machine as well as the OLS station. Is this a problem that can be fixed by us or do the f