Electronics Forum | Wed Jun 22 15:35:09 EDT 2016 | mikemoriel
Hi all, I have a problem on my 265 GSX printer. "Position error" on the rising table. Machine was running fine and then out of the blue the error occurs, takes a few power downs and not working... The table does not move then error occurs...
Electronics Forum | Fri Jul 17 19:43:20 EDT 2009 | fujiphil
Have you eliminated the hardware N.G.? Check the connection for the rear door. If the connection are ok, try to bypass the key. short the two wires for the rear door. If the rear door problem is corrected, check the rear door switch physically. Reg
Electronics Forum | Fri Jan 05 10:58:43 EST 2018 | ilavu
John, I just found out more detail. If my board stop position in x is bigger than 109mm, I get error from park position to board stop.This problem started after power loss. The error comes up system power down and after pressing system button "RISIN
Electronics Forum | Fri Feb 16 05:39:56 EST 2018 | abo2016
we came across the following error this morning while working on the DEK 248 screen printer. Table in/out error message. Can we be assisted with fixing this please..
Electronics Forum | Fri Mar 13 18:37:16 EDT 2020 | sarason
This error is an error from an Access database table. SO could be a damaged database file, a locked file associated with administration priviledges, or maybe the file server isn't running or there has been a change of file server ID etc. sarason
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Wed May 05 04:25:42 EDT 2010 | vms
We sale the cognex cards for 3500.00 all of the time, think we need to raise our prices. Right bruce? Harry
Electronics Forum | Mon Nov 18 02:45:06 EST 2013 | sara_npi
Hi What is "fatal error"? Every time when operator raise head to add cleaning paper or add solvent machine just hang like that. need to reboot machine. Pls advise Thanks.
Electronics Forum | Mon Sep 20 14:23:50 EDT 2010 | dekhead
No, there is not a way to initialise into the diagnostics menu with the head raised / covers open. Literally lowering the head manually (prop head, disconnect actuator, etc) is naturally possible, but not receommended... and based upon your symptom
Electronics Forum | Tue Sep 19 10:30:54 EDT 2006 | dekhead
I think you may be remembering wrong. Timer circuit will normally cause table drop when system power is re-applied, not when it is removed.