Electronics Forum | Thu Apr 15 20:07:38 EDT 2010 | userrich
"BiRAL SC" is a water displacing cleaner. - effective for cleaning most metals including carbon- and stainless steel, copper, aluminium etc. - cleans electrical motors, brush holders, bearings, armatures etc, - cleans and treats most types of plastic
Electronics Forum | Fri Jul 10 07:34:00 EDT 2020 | elijah
From the poor bonding strength of the board, the surface quality problems of the board are divided into: 1. The cleanliness of the board surface; 2. The problem of micro graphite (or surface energy) on the surface. PCB circuit board proofing Youke bo
Electronics Forum | Wed Jan 30 13:45:59 EST 2019 | slthomas
I'm wrestling with the infamous adjustable torque drivers on the production floor. Despite a procedure that clearly forbids it, we still have the occasional know-it-all that will just crank the knob until the desired setting is visible in the windo
Electronics Forum | Mon May 14 17:12:20 EDT 2001 | davef
Continuing along the path that Brian took ... IPC-7525 gives design guideline for stepped stencils. It goes something like: * Stepped area SB GT 25 thou from pads located on the greatest thickness of the stencil * Pads in stepped area SB GT 35 tho
Electronics Forum | Wed Jun 10 18:40:00 EDT 1998 | Earl Moon
| I am looking for the Industry standards on vias. Are they required to be plated with solder or is copper plating enough? What about reliabilty with either one? Also, if tenting the via is required should it be copper plated or solder plated over
Electronics Forum | Tue Jun 20 20:31:12 EDT 2000 | Dave F
Chrys you're fine. On scoring: * Be sure spec material remaining, not what is removed. * Be sure that the v-grooves are perpendicular to each other, not off set. * Typ spec for for .062 thick boards FR-4 0.018-0.024 MC-3 0.030-0.040 * HADCO recomm
Electronics Forum | Thu Apr 14 06:00:01 EDT 2005 | bryan
The shelf life of immersion silver is 6 to 12 months in good storage conditions. The finish is usually coated with a protective layer that inhibits oxidation (like with copper OSP). Care must be taken when handling the boards as the protective la
Electronics Forum | Thu Nov 16 11:45:15 EST 2006 | markb
I still think the best bet is probably an SMT pre-bake operation to ensure that there is no moisture in the board. Vapor pressure is usually the leading cause for delamination, so removing the source should significantly help out. Unfortuantely, pr
Electronics Forum | Thu Apr 22 09:28:22 EDT 1999 | Michael N.
Well Dave what are pads on the ceramic board is composed of is Paladium Silver but it is on the bottom, then comes the copper, then it is coated with tin, then it is coated again with nickel. What makes it even harder is that are devices are Gold lea
Electronics Forum | Tue Jul 08 12:11:17 EDT 2008 | gabriella
Hello, you will probably need more temperature. Notebook - probably the board is designed to transfer more heat(insude layers all copper). Tell us more about the problem you have and something about the board. what exactly is your problem? You can't
