Electronics Forum | Wed May 25 10:01:59 EDT 2016 | stevedc
I tend to get issue on and off with the feeders either stalling and/or running slow/noisy. They are actually pretty easy to clean and maintain. If you take off the side panel of the feeder you will see a few gears, belts and a motor. The first thin
Electronics Forum | Wed Jul 05 17:06:36 EDT 2000 | Michael Parker
Patrick- You have not given enought detail of the type of discoloration. Is it "white residue"? Can it be "rust" colored? Whatever it is, you fab supplier needs to be called in immediately and give you an exact reason for this failure. Just rubbing
Electronics Forum | Fri Jun 23 14:10:01 EDT 2000 | Chrys Shea
Sounds like the mask to me. Had a similar situation a couple years ago. The mask wasn't fully cured, so it absorbed water that the preheaters couldn't dry out. When it outgassed at the wave, it caused a lot of micro turbulence that broke the surfa
Electronics Forum | Tue Feb 06 13:02:36 EST 2001 | kmorris
Hi all: We are seeing "solder webbing" on the bottom side of some of our PCBs after wave solder. The solder is sticking (like a spider web) to the solder mask on the PCB. This is only happening on 2 of the many PCBs we wave on that machine. Both o
Electronics Forum | Fri Mar 02 09:08:10 EST 2001 | markkrmp
Frank, I am not talking about the masking on the PCB. I am actually talking about the masking on the solder side of the BGA. We have a very very high dollar BGA and are trying to reclaim alot for reuse. When we remove the BGA from the assembly, you
Electronics Forum | Wed Jun 27 20:01:48 EDT 2001 | mparker
Having read about your "dream", I can sympathize but gotta ask why did you feel compelled to write about this on a Sunday at noon? could it be that Chorizo enchilada with pickle sauce, downed with a jug of Ouzo on Saturday night have something to do
Electronics Forum | Fri Feb 08 08:00:48 EST 2002 | caldon
Yet Again Dave spills his pearls of wisdom. Dave is correct in the moisture content wood absorbs. I know we have all visited factories with wood board holders and such. I have actually seen wood carts with drag chains. Also, keep in mind static can b
Electronics Forum | Wed Mar 20 13:49:15 EST 2002 | cabjerk
Hi All; The following is from our Support people who worked with Fuji on the problem; Last week Luke Mittur and John Gudel were in from Fuji to address the IP3 issue outlined below. The problem ended up being that the table "up" and table "dow
Electronics Forum | Fri Oct 18 16:24:05 EDT 2002 | russ
Big BIG BIGG wave with a lot of preheat capability both top and bottom. You may need to exceed the standard "100 C" top side preheat to 120C or so (be aware of any topside SMT going into reflow over the wave). A spray fluxer with very fine atomizati
Electronics Forum | Thu Nov 07 12:51:09 EST 2002 | slthomas
This is embarassing. I've used ipa (actually "70/30 rubbing" alcohol) to clean these for a better view (this is a no-clean), and found the above described anomaly to be intact. So, I assumed it was something in the solder itself. Well, today I us