Electronics Forum | Fri Jul 30 13:39:45 EDT 1999 | Upinder Singh
Hi all, What is the typical placement head pressure for the GSM1 for placing the micro / chip Scale BGAs ? Thanks Upinder =======
Electronics Forum | Mon Sep 14 11:29:11 EDT 1998 | Anderson Dutra
Reading some technical report I found the term "CSP", but no explanation. I guess something about Chip Scale Package... but not sure. Could someone please explain it to me? Rgds, Anderson
Electronics Forum | Thu Jun 18 17:20:24 EDT 1998 | Dave
I am currently using some pick & place equipment and would like to measure their cpk using a glass plate and glass "components" with vernier scales. I have seen these kits but am trying to track a supplier down in UK/Europe. Any help is much apprecia
Electronics Forum | Wed Sep 19 11:32:17 EDT 2001 | Mike Konrad
Hi Kevin, Sorry for the delay in responding to your question. I have been trapped in Australia (not a bad place to be trapped I may add). The scale in your cleaner is not usually caused by the chemical used in the wash cycle (although Armakleen ha
Electronics Forum | Fri Dec 19 09:57:07 EST 2003 | davef
We agree with Deano. Can you use ENIG on your board?
Electronics Forum | Tue Aug 03 07:52:27 EDT 2004 | davef
Look here: http://swz.salary.com/salarywizard/layoutscripts/swzl_compresult.asp?NarrowCode=SC04&NarrowDesc=Manufacturing&JobTitle=Manufacturing+Engineer+I&JobCode=EN04100018≥o=U.S.%20National%20Averages
Electronics Forum | Wed Aug 04 11:23:40 EDT 2004 | mmjm_1099
Yes I second that on wishing I didnt look at that damn thing. Well to make it even better for all of use check this out. http://swz.salary.com/salarytimer/layoutscripts/stml_start.asp
Electronics Forum | Sun May 22 23:26:38 EDT 2005 | thaqalain
The number of cycles shown on a scope for a given frequency is determined using 1-Sweep frequency 2-Volatge Scale 3-Ohm's Law
Electronics Forum | Thu May 26 15:20:13 EDT 2005 | jh0n!
I'm also looking at a CAM system for our NPI process, but want a system that scales up through data collection off the machines, and from our technicians. The Aegis suite of software looked awesome, but not at into a six-figure pricetag.
Electronics Forum | Wed Jun 01 16:18:43 EDT 2005 | AlanJ
Prices are nice but the quality is very poor. I don't think they are at a point where they can manufacture quality equipment (soldering stations excluded) as it is mostly done on a low volume scale.
