Electronics Forum | Fri Jun 24 04:42:12 EDT 2005 | ajaydoshi
We do have BTU 150 Paragon. What the practical air setting for all 10 zones + 2 coolig zone. This setting is to manually adjust on machine front right botton side. ajay
Electronics Forum | Wed Jun 18 07:48:29 EDT 2008 | gemengr
vo^ cai' tab pick vacuum% set at 30 and tab mount vacuum % set at 30 . neu^' va^n~ con` bi. thi` set lai vacuum cho nozzle #72 in machine data. by the way duyHoang o*? ddau^ zi?? good luck
Electronics Forum | Mon Jan 03 14:38:42 EST 2011 | leemeyer
I had this problem awhile back and it turned out to be a problem with the computer Bios settings. The battery had gone dead and the settings were set back to the default state. Luckily I have 2 of these machines and was able to reset the Bios configu
Electronics Forum | Mon Mar 07 12:28:20 EST 2011 | rodrigo
I check the board options tab under the "General" menu and it is set to "no good". There is a "System Settings" that I can go into, but the button that says "Settings" is greyed out. The list shows that the marker is "installed". Neither the pen move
Electronics Forum | Mon Nov 18 09:04:20 EST 2019 | davef
Review: * Too much placement force * Underside supports are set incorrectly * Component height set incorrectly * Downstroke location of either the pick or placement set incorrectly * Nozzle that is smaller than recommended for the part * Part
Electronics Forum | Thu Oct 06 06:31:45 EDT 2022 | hta1979
Hi all ! We changed the repick setting of a part in Siplace Pro. But when we sent it to the machine, the setting did not change. My question is,it possible that this option only works with the 505 station software? This is an F5HM,we have 406 softwa
Electronics Forum | Thu Oct 27 20:32:43 EDT 2022 | oxygensmd
Hello. - Pickup offset works on with or above 505 softwares. - Offset correction works on feeders but the ProDesk won't overwrite your current SetUp / feeder cart. You have to overwrite manually or make new SetUp in Job (using optimalization),
Electronics Forum | Sat Feb 03 01:57:17 EST 2024 | heinar
Hi, does anyone have quad QSP-2+ with motherboard 5x86. I, needed bios setting both computers. Have manual, but different. I have bios settings for 4x86, when needed then ask.
Electronics Forum | Tue Apr 16 20:38:03 EDT 2024 | digitalshovel
when in assign mode, set npm1 as pass. The condition set will make it pass through to npm2
Electronics Forum | Fri Mar 18 15:02:07 EST 2005 | pmd
Please clarify, Z axis gears (Blades)? The MPM head I believe is what your are asking is driven up and down via a lead screw. The machine gets the zero point from the "HAT" tactile sensor in the table nest. When squegees are installed the blades are