Electronics Forum | Wed Aug 22 14:39:02 EDT 2012 | wendynguyen234
Our S-2000 pick & place machine has head 2 not picking up any nozzle & displays error code 8342(nozzle check error). In ANC setting, head 1 pick/put ok but not head 2; when "MANUAL" box is checked, clicking PICK/PUT then both head 1 & 2's status disp
Electronics Forum | Mon Jun 16 14:39:49 EDT 2003 | stepheno
The second one is typical. The important temperature is the temperature of the joint, not the setting of the oven. The oven setting are only important because they determine the temperature of the joint. If you set the oven to 150, that will be th
Electronics Forum | Fri Aug 07 14:52:43 EDT 2020 | glasscake
Does anyone have a comprehensive manual or some pages on how to setup/how the laser height functions work on a Mirtec MV-7U? (Mirtec Inspector 4.5.6) Even a sentence describing what each input for these tools do would be amazing. I FINALLY was able
Electronics Forum | Mon Jan 09 19:25:15 EST 2017 | fadzril
It shouldn't be any issue if you measure the top reflow settings using bottom profile board & the results are OK. To common the reflow profile, both bottom & top profile measurement are taken & analyzed. This, too, can be applied, even for differen
Electronics Forum | Mon Mar 09 03:45:19 EDT 2009 | nagesh
I have a double sided assembly board having more no. of QFP's & IC's at both Top & bottom.Is there any concern about this??.COz. i have the profile set to be almost same for Top & Bottom.Worried whether bottom side IC's fall/ Shift during Top side re
Electronics Forum | Fri Dec 02 01:49:48 EST 2016 | jeya7376
I want to do improvement in conversion time. We running small quantity board and frequently do conversion. we produce very simple board no BGA only resistor, capacitor, LED, IC and transistor. We are running same model top and bottom in 1 reflow oven
Electronics Forum | Mon Mar 08 23:43:54 EST 1999 | Dean
> Alignment issues are not so critical on most any system, but thermal >>(top and bottom heater settings) certainly are. Without a serious >>system, I just don't see how it can be done. | | | | Thanks again Earl for your valuable communications..
Electronics Forum | Wed Jun 07 22:07:47 EDT 2006 | Wave Master Larry
Listen Samir, we some times spray the tops of our baords at wave to achieve top side wetting. Not sure if the engineers aren't setting up the wave right or not, but it gets the jwob done. We don't see any fall out from this and have been doing it f
Electronics Forum | Thu Jul 18 04:42:32 EDT 2013 | ericrr
Thanks for that, sorry Im late setting (set by someone else) Speedline Bravo Top 1st chamber, 2nd, 3rd, 4th. 170° (c), 180°, 190°, 270°. Bottom 170°, 180°, 180°, 260° chain speed 27cm/second.
Electronics Forum | Thu Feb 15 13:46:16 EST 2018 | aemery
Griinder, Maybe it's me, but I think what you might be saying here is that you see a reflected image of the PCB or Stencil when you and teaching the fiducials and it is interfering with the teaching routine, is that correct? If this is true it is c