Electronics Forum | Fri Jul 16 05:24:40 EDT 1999 | Chris May
| I'm looking into vision inspection equipment to automatically inspect SMD placement and solder joint quality. Does anyone have any recommendations or know of any commonly used equipment? Do other manufacturers use vision systems at their inspecti
Electronics Forum | Thu Nov 11 13:03:01 EST 1999 | Jeff Sanchez
Thanks John, That's a nice site. It had some good training stuff as well. I had seen a thread here on the forum for this same question and someone posted this link www.practicalcomponents.com . It gives all the package sizes and dementions as
Electronics Forum | Sat Sep 06 05:11:21 EDT 2014 | padmalathab
Hi Thanks for responding to my query. Our PCB Assembly consists of both SMD and THD components. Also,assembly will be done by machine as well as Hand soldering based on the requirement. I request you to suggest Poka yoka tool to read the value of
Electronics Forum | Wed Nov 16 20:17:51 EST 2022 | cyber_wolf
For a number of years now, work has been proceeding in order to bring perfection to the crudely conceived idea of SMT that would not only supply inverse reactive current for use in unilateral phase detractors, but would also be capable of automatical
Electronics Forum | Thu Jul 15 16:07:39 EDT 1999 | Doug
| | I'm looking into vision inspection equipment to automatically inspect SMD placement and solder joint quality. Does anyone have any recommendations or know of any commonly used equipment? Do other manufacturers use vision systems at their inspec
Electronics Forum | Mon Jan 31 15:02:52 EST 2005 | gs
First of all ask your Suplliers to provide you SMD in Tape & reel, second point, you can ask Service for Tape & Reel or in case components are not so many, you could asses ef convenient to buy a sinple maual Tape & Ree machine and do it inside your f
Electronics Forum | Thu Nov 17 21:46:48 EST 2005 | C. Kolokoy
With DIP type components, a sub-par fluxing method (foaming a no-clean), and a chip wave where one is not needed are formulas for bridging and insufficient wetting. If you have SMD's on the wave solder side of the board greater than 0603, and no SOT
Electronics Forum | Tue Nov 15 16:07:39 EST 2022 | corusak
Hello everyone, I am working on a very low cost, small and basic vending machine ($300) with wooden cabinet for small neighborhood stores. As you may know, it is necessary to properly protect the components to prevent users from trying to steal money
Electronics Forum | Mon Aug 03 08:29:24 EDT 1998 | Dave F
SMD: Sounds interesting. What is the contact information on Steve? Dave F | Right now we are taping the goldfingers which is | effective but also expensive. Also, some tape was leaving yellow marks on the goldfingers. We're trying the so-called go
Electronics Forum | Thu Sep 19 15:06:39 EDT 2013 | jvadillo
We have already one desktop oven and a manual stencil printer. And we have a quite complete soldering bench with several JBC tools. We also have stock for all active elements we use. We normally relay on the PCB assembler to provide the passive comp
