Electronics Forum | Thu Apr 24 13:58:40 EDT 2003 | jbservices
SR try this web site for some spec. thanks john www.contax.co.uk
Electronics Forum | Fri Jan 21 19:20:31 EST 2022 | SMTA-64304163
Can someone who designs IMS printed circuit boards advise us on how to document the materials on the drawing. We are looking for applicable specifications to reference along with the physical specs. The current design is 066 +/-.006. .059 al, .0028
Electronics Forum | Thu Sep 08 13:40:39 EDT 2005 | rcegan
Can someone please Help me. I just recived a request from my CM asking for informtion for Kodak Q-1003 specs, apperantly ther's a file in the gerber files for PS08799 Rev D � 4 layer board that refers to this spec.
Electronics Forum | Wed Oct 12 11:19:46 EDT 2005 | patrickbruneel
Yeah, adopting is the right word. In this new lead-free era spec.'s are made to stay within the scoop of the RoHS directive. The driving force for spec.'s should be reliability. Did you see any impurity level spec.'s yet in wave soldering for Cu, Au,
Electronics Forum | Mon May 21 04:37:41 EDT 2001 | Bob
Hi, Kris You mean you have checked the tape&component demension,all in spec, But could you tell me the spec of the tape cave size,I mean how about the gap between the cave and component? Do you have such spec.for 0402 Component? Please inform us
Electronics Forum | Thu Oct 07 12:17:09 EDT 1999 | Bob Barr
The last time I worked with this spec (and it has been a while) it was MIL-C-28809, not 'P'. Try searching for that. There is a good chance this document has been obsoleted in favor of an IPC spec. Good luck. Bob | Is anyone aware of a web pag
Electronics Forum | Fri Aug 14 08:30:44 EDT 1998 | Pat Copeland
Where can I find a spec to put on my fab drawing, to call out the cleanliness of the board, before I recieve it. These boards will require a tight spec after they are assembled, so I want to know that they are clean when I get them. Any suggestions.
Electronics Forum | Wed Jun 03 08:51:07 EDT 1998 | Pat Copeland
Can anyone tell me if there is a reference for smt component height specs on the bottom side of a board, which will also go through wave soldering. A current design I am reviewing has tant caps(7343) and a crystal on the back side. Should I only be
Electronics Forum | Wed Aug 30 08:59:40 EDT 2006 | saaitk
Our facility in Asia wants to change their solder paste to a local manufacturer. I have recieved specs for this paste and compared to our existing paste spec, there is not really much difference in material composition. The Asia spec tests the paste
Electronics Forum | Wed Jun 20 11:51:55 EDT 2001 | Steve
Speculation is dangerous. If the test is part of the spec and your CM assures you that it is being done, unless you have a high failure rate, you need to believe it is happening. If you have seen an increase in failures, I would defenately call the