Electronics Forum | Fri Mar 16 08:42:25 EDT 2007 | AR
Of course, if the number of required component codes ( = feeders) is not very great, you might want to look into odd-form assembly machines. With them you can insert a much greater range of components than just simple radial components and you can ge
Electronics Forum | Sat Oct 18 20:35:25 EDT 2008 | arosario
I see, maybe changing my peak temp in reflow will help. I'll try do eval again... Actually, once I did have evaluated a longer pre-heat but on my previous eval, I didn't change the peak temp. Maybe reflow can help compensate to my problem in the part
Electronics Forum | Tue Feb 09 16:04:06 EST 2010 | frankalbiter
Hi there, From the ISO 13485: 2003 std. standpoint, there is a special requirement which states: "The following requirements shall apply. d) If appropriate, special arrangements shall be established and documented for the control of contaminated or
Electronics Forum | Thu Feb 16 02:44:03 EST 2012 | fadzril
Dear all, Have anyone deal with X-Out boards? These defects are declared if one cavity or more from multi cavity boards are defective. There have been a request to use these boards in order to reduce the multi cavity board spoilage at supplier. Ho
Electronics Forum | Wed Oct 11 06:57:52 EDT 2000 | jackofalltrades
Yes, Metcals do work. The parts come off and clean-up very nicely with a hot tip. Nothing really special needed.
Electronics Forum | Thu Sep 14 14:08:41 EDT 2000 | Bob P
We are currently looking for a new vendor who specializes in selective wave solder fixtures within Southern New Hampshire or Mass. Can anyone recommend a good supplier(s)?
Electronics Forum | Wed Sep 13 12:01:26 EDT 2000 | Wolfgang Busko
Hi Charly, short question, short answer: excessive mechanical influence often in combination with bad solderjoint itself. For bad solderjoints there are many many reasons, process and material related. Are there any special circumstances that made y
Electronics Forum | Wed Sep 06 20:26:35 EDT 2000 | Greg
Hi, anybody there can help me figure out the degree of misalignment specially on RC components when they're inside the reflow oven? thanks
Electronics Forum | Thu Aug 24 22:19:24 EDT 2000 | george
Hi Guys, Wonder what and how other companies clean their squeegees and stencils after stencil printing adhesives. Can anyone give me a clear skies about the above process? We do not have any special cleaner at the moment. all ideas are welcome... t
Electronics Forum | Sat Aug 05 03:09:54 EDT 2000 | Felix
Dear Netters, Could anybody kindly advise : 1. what step stencil means 2. what are its characteristic ?? 3. What special process makes it? 4. What is the application ?? 5. Advantages and limitation ?? just short breifing is enough. Thanks Best