Electronics Forum | Wed Mar 17 12:19:53 EST 1999 | Scott Cook
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Tue Feb 27 10:26:19 EST 2001 | jcboetcher
Hi I'm a first time user of SMTnet. I have a Electrovert Wave Soldering Machine Ultra 2000 with a AT&T Spray Fluxer. I'm looking for a upgrade or a replacement Spray Gum Binks Model No. Z-6-434 and or nozzles ( Fluid tip assembly No. 184A / 156A.
Electronics Forum | Thu Dec 23 22:31:47 EST 1999 | Vincent Chen
Hi!Charlie, 1.Are you retrofitting your spray fluxer in your wave soldering machine? If you are, please ensure that you have a air knife just before the preheater!Fluxe fumes tends to accumulate and that could be dangerous if your air exhaust is not
Electronics Forum | Wed May 19 15:23:07 EDT 1999 | Justin Medernach
Hi All, I'm getting an Electrovert Wave. It's the replacement for the Econopak. I can't remember the name. Either way, the spray fluxer is made by USI. Does anyone have experience with this spray fluxer. Good or bad would be appreciated. Thanks
Electronics Forum | Fri Apr 05 20:56:17 EST 2002 | cycorda
Dave, Some spray fluxers are a lot more efficient than others - some will have such little waste that most of it is carried out by the exhaust. One of the benefits of spray fluxing should be that it creates very little excess flux, therefore no n
Electronics Forum | Thu Aug 01 15:50:15 EDT 2002 | pjc
I had a 1995 SENSBEY MXL-400J at the last place I worked. I had very good results- easy to setup, run and maintain. It has a paint gun type spray head. Good idea to have spares cause they can clog. I sprayed a Multicore NC flux. Only downer was a fai
Electronics Forum | Thu Aug 17 15:13:41 EDT 2006 | samir
I hear Pillarhouse is the "Yugo" of Select soldering! :) Chunks et al is correct that if the innards of the fluxing system are made of non-corrosive mat'ls, you should be okay. I used to deal with the original AT&T Spray fluxers and their spray no
Electronics Forum | Wed Oct 25 12:55:17 EDT 2006 | russ
Definitely better than foam!! I personally love the sonoteks. They do not really use a "nozzle" by the way. The flux is pooled on U.S. head and it atomizes it and then you have air spray to form proper spray pattern, If you are using Water soluble
Electronics Forum | Fri May 29 23:19:46 EDT 2009 | isd_jwendell
I too have heard of the ESD problem when using aerosol spray conformal coating, but I haven't found any documentation. I have been spraying SR conformal coating for ~ 10,000 boards with no failures due to the coating. The person spraying is grounded
Electronics Forum | Mon Jul 13 11:21:52 EDT 2020 | dontfeedphils
1) Viscosity measurement of the coating prior to spray, spraying and charting metal coupons for sprayed and cured thickness of the coating at various points of the conformal coat run 2) Yes, manual inspection 3) No, it wasn't able to inspect with t
