Electronics Forum | Thu Feb 29 02:24:55 EST 2024 | redspare1
Strange error, I have looked at the schematic and checked all of the e-stop switches and they're good. The machine isn't connected to anything, but air and power. Has anyone else seen anything like this? 1. When pressing the active button it beeps
Electronics Forum | Sat Aug 19 22:54:12 EDT 2023 | sonavc
Hi The machine run fine. Now I had the problem ZL or ZR driver Alarm. Turn on machine, everything is checked O.K I can be able to home the machine. When just start auto, the assembly or semi -auto. The machine is stopped, and show driver alarm ZL or
Electronics Forum | Sat May 08 02:46:23 EDT 2004 | Richard
This machine was working fine, now it come up with an emergency stop error "STOPPER", will not get past it, I have checked the board stoppers and all seem to be working correctly from the Manual IO. I did have to reload the 'proper' data, any body go
Electronics Forum | Wed Dec 12 15:00:43 EST 2007 | mefunak
Hi,everybody! There is an interesting things happened with the 0402 components- machine Siemens HF3,it's an Emergency Stop error message " Component not at nozzle before placement" and there is a chance to find an extra components lying in a mess on
Electronics Forum | Thu Sep 24 00:52:41 EDT 2015 | ermani9
Hi.. Move the XY arm to the center of the machine. Turn on the servo then immediately hold “LOWER” then press “ORIGIN”. You should see the message now on the screen “DRIFT CHECK”. The arm will start to drift without an emergency condition occurr
Electronics Forum | Thu Jun 08 18:40:44 EDT 2017 | simons
We have a Samsung that we have replaced all the amps and are still getting the Z axis motor alarm failure. On the “Position Window” before and after we try to “Home” the machine, the values for “Z-Axis” for all three heads prior to the “Home” action
Electronics Forum | Fri Feb 01 01:46:46 EST 2008 | jola
Hi. There is no problem with the exhaust system and the owen also has a sensor to messure the exhaust and would give an alarm if it stopped or went under a preset value. We have had our owens for one year now and the problem just started suddenly, we
Electronics Forum | Thu Aug 21 16:33:49 EDT 2008 | decaire
The 2 most common approaches for MSD Tracking and Control on the factory floor are: 1) Manual paper-based procedures (Example: Log Sheet or Label that the operator must fill out and pay attention to) - or - 2) Software-based tracking system (Example
Electronics Forum | Fri Mar 23 02:22:13 EDT 2007 | bvdb
Latest information: The IP-1 packed up completely this week showing an assortment of weird error messages. The CPU was still running but the +24VDC power supply LED was off and nothing would work (emergency stop mode always enabled). Pulling the +
Electronics Forum | Mon Mar 30 15:16:32 EDT 2009 | Peter
Hi Tom, You're right. I do find the second locating pin hardware. Now I got them both up/down when F3 is pressed. Thanks. I don't see any pin on the hardware and no edge clamp hardware either :-( , do you know any way that I can bypass these hardware