Electronics Forum | Mon Dec 09 20:34:20 EST 2002 | MA/NY DDave
Hi I hear you, and you are right, yet most good process engineers strive to make future life a little easier by going back to the designers and making some alterations that don't affect performance. Now if we did a 6 sigma type analysis than this p
Electronics Forum | Wed Jun 27 21:05:48 EDT 2001 | davef
BGA Cycle 1: solder ball attach. BGA Cycle 2: BGA attach to board. BGA Cycle 3: BGA removal from board. BGA Cycle 4: BGA pad dress. BGA Cycle 5: BGA ball replacement. BGA Cycle 6: BGA re-attach to board. Board Cycle 1: BGA attach to board. Boar
Electronics Forum | Thu Jun 14 01:04:57 EDT 2001 | procon
Ian, It appears to me you are trying to reflow the star wars project. All this talk about thermal absorbtion, heat differential, etc., it' only a reflow profile? If you read back over the suggestions of all other memos, you will find the solution.
Electronics Forum | Thu Jan 01 13:04:42 EST 1998 | scott cook
| Has anyone had any experience with thermal shocking | and cracking of SMD capacitors during the rework process? | My company was advised to preheat capacitors to 125 C | at a rate of 2 C/sec before replacing them onto boards. | Would this maybe
Electronics Forum | Tue May 13 08:59:13 EDT 2014 | gazelle
Hello davef - could it be you are confusing low thermal emf (Seebeck coefficient) with low temperature solder ? I am looking after solder wire and paste with low Seebeck coefficient - cadmium based alloy was OK but banned in europe due to RoHs direct
Electronics Forum | Sun Jun 10 21:18:06 EDT 2001 | ianchan
Hi Guys, Thanks for the tips, will try it on next run. Regards, ianchan :)
Electronics Forum | Tue Jun 12 20:59:14 EDT 2001 | ianchan
Hi mates, actually my whole problem, is whether to : 1) To offset the heat-absorb ability of the Pallet, that artifically lowers my pcba temperature, is it advisable to artifically increase the overall, oven zone temperatures? offset by estimated +
Electronics Forum | Tue Sep 28 12:23:07 EDT 2021 | aex
reflow profiles are actually 20F above set points
Electronics Forum | Tue Sep 28 12:23:50 EDT 2021 | aex
Thank you. Checking the fans and pressure this morning.
Electronics Forum | Fri Jun 06 06:11:18 EDT 2014 | paulg
I have a large monoblock ceramic filter on a PTFE based pcb material. The filter has a metal casing soldered onto the ceramic filter. I am concerned that if the heating rate is to rapid, then thermal shock / differential expansion could cause the fil
