Electronics Forum | Thu Sep 05 23:32:29 EDT 2013 | winson16
This connector was designed with gold flash plating and the lead's surface was become dull and some black mark was observed on the contact surface.
Electronics Forum | Fri Sep 06 07:40:02 EDT 2013 | spoiltforchoice
gold, one of the stablest elements on the periodic table oxidising. Are you sure, and why would you want to reduce the vision fail rate on a part that is clearly shockingly poor?
Electronics Forum | Mon Sep 23 14:26:27 EDT 2013 | joekirin
On machines such as MyDatas you have the ability to mechanically center parts rather than optically centering. If your machine is capable of doing mechanical centering that would eliminate the need for the vision analysis. -Joe
Electronics Forum | Thu Sep 26 02:15:32 EDT 2013 | winson16
Thanks Joe. I will check through this with machine supplier to understand what's their machine's ability of doing this.
Electronics Forum | Fri Jul 18 15:25:19 EDT 2014 | davef
The presence of agitation at an air / solution interface and a foaming agent causes foaming. Most water soluble fluxes contain surficants. Surficants are foaming agents. First, it's likely this foaming is caused by poor control of the temperature of
Electronics Forum | Tue Nov 14 23:49:37 EST 2000 | DL
Our land patterns are slightly bigger than the part, we've had no problems. There are your own concerns about the part hanging over the pads, this can be ok or not depending on your application and/or how much part is over. I'm sure this is in the J-
Electronics Forum | Sun Jun 26 04:08:40 EDT 2005 | fastek
If you have a virus protection software in place it is likely slowing your system down to a crawl. Disable it and see if your results are better. You can also do a ctrl+alt+del. Go to "Processes" and take a look at what is bringing down your speed. H
Electronics Forum | Mon Jul 04 08:13:54 EDT 2005 | Tom B
Setting Speed for Ram is usually in the BIOS set up, Pressing DEL key, or F1, or ESC should bring you into the screen. It will usualy tell you on boot up. Look in there for the setting. Other times its a jumper setting on the motherboard. 7200 & 1
Electronics Forum | Wed Sep 04 22:48:13 EDT 2013 | winson16
SMT fine pitch connector having oxidation on lead and P&P machine keep rejecting the part. Is there any alternative way to reduce the part throw out rate without jeopardize the placement accuracy? Or is it possible to re-coat the connector lead or an
Electronics Forum | Tue Sep 24 04:14:25 EDT 2013 | winson16
Hi Joe, first of all thanks for your input. I did tried to search for the Mydata brochure and found that they are using Lifescan Vision System (LVS) which i think should be vision analysis. Appreciate if you can explain more in detail how's the mecha