Electronics Forum | Mon Jul 17 15:35:09 EDT 2017 | svfeingold
Evtimov, I thank you for your response. I posted a thread about this on EEVBlog but there is less experience there for this type of equipment it would seem. If your interested there's a lot more detail about what I'm after: http://www.eevblog.com/for
Electronics Forum | Mon Jul 13 06:30:59 EDT 2009 | hcarrasco
1.- Check your vacuum a.- Check filters b.- Check air flow (the vacuum is generated by a Ventury using air flow, not air pressure) c.- Vaccum vias (Possible linth inside the vacuum lines) 2.- Check the nozzle condition (Probably broken o
Electronics Forum | Tue Feb 02 11:07:36 EST 1999 | justin.medernach@flextronics.com
| Greetings, | | We are discussing what should and what should not be baked and vacuum packed. Should we just concentrate on the fine pitch packages and the bga's? | What about those components which come on blister tape, should they get baked and r
Electronics Forum | Fri Sep 29 04:43:12 EDT 2017 | spoiltforchoice
Interesting, I work much the same way as Ivan up to the sticky tape part, plodding through the BOM against the pick and place file and downloading the relevant datasheets to verify packages, this can be tedious but usually gets much quicker the more
Electronics Forum | Sun Nov 07 10:54:21 EST 1999 | Steve Thomas
We're looking at redesigning our stencils to facilitate better (well, it's pretty much non-existant, so any improvement is a big leap) release from fine pitch apertures. Currently we have perpendicular walled laser cut apertures. We'll be having
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Mon Oct 24 01:19:10 EDT 2005 | darby
Hi Mike, I use variations of both of these machines in a Tenryu FV-7100s and Samsung CP45/CP45Neos. Both have been very good machines - I would find it difficult to split them. I have personal dislikes of both tooling and support systems. I would ta
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Mon Apr 26 09:18:27 EDT 1999 | C.K.
| | | | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free so
Electronics Forum | Sun Apr 25 12:05:50 EDT 1999 | Chrys Shea
| | | Has anyone had trouble waving and gluing 0603 R's and C's? At my company, our designers have "opened the floodgates" on bottom-side 0603's. | | | | | | We've got an EPK+ with rotary chip and omega wave but can't seem to get skip-free solderin