Electronics Forum | Thu May 20 07:53:55 EDT 1999 | Chris Nuttall
| | We care currently running into problems during our plug via process: | | At the moment we plug prior to soldermask (LPISM) using epoxy resin - plugging takes place from the component side - however we are seeing solderballs after solder level.Thi
Electronics Forum | Tue Mar 22 08:05:59 EST 2005 | jdumont
Morning all, my question is regarding the use of filled/tented/plugged vias on the BGA site. What are you guys doing for this? What type of issues can this cause if using none, or the improper via design. Regards, JD
Electronics Forum | Thu Feb 15 13:49:10 EST 2007 | russ
only plug one side, you can definitely blow out during reflow process with a sealed via/ it is impossible for flux to be trapped in a blind via. Russ
Electronics Forum | Mon Nov 05 06:27:23 EST 2007 | grantp
Hi, We are also interested in this, and I have heard you can get the PCB's with the via's plugged. Also, if the via's are small, the solder should not penetrate? Anyone have any further info? Grant
Electronics Forum | Thu Mar 03 08:06:36 EST 2011 | scottp
I've seen this with through hole via in pad with soldermask plugging from the opposite side. Baking the boards solved it. Not using such a horrible via in pad method would also have solved it, but that wasn't an option. Is this ball sitting on a v
Electronics Forum | Tue Feb 19 11:08:22 EST 2002 | Chris Anglin
Guideline for Tenting Interstitial BGA Vias It is difficult to give a complete recommendation on via tenting without an idea what process conditions are required (ex: wave pass, double reflow, rework etc.). Via Pads (as Test Points) - On Bottom
Electronics Forum | Fri Nov 03 07:28:27 EST 2006 | davef
Via filling methods are: * Tenting * Plugging * Capping * Flooding Tented Via. A via covered with dry film soldermask; the via is not filled. When tenting from both sides there may be issues with trapped air that expands during mass soldering. Plug
Electronics Forum | Sun Dec 26 21:24:55 EST 2004 | tellinghuisen
Dreamsniper What is the rationale for the double plugging? And why from both sides?
Electronics Forum | Mon Nov 05 07:22:02 EST 2007 | aj
Hi, We have had this before - yes they can be plugged and metalised on top . aj...
Electronics Forum | Mon Mar 04 17:52:59 EST 2002 | davef
Yes, providing the surface of the via is solderable. * If so, how much paste? => Vias come in various sizes. Boards vary in thickness. So, the amount of paste to fill a via varies. Roughly, you�ll need twice as much paste as the volume of the via
