Electronics Forum | Thu Aug 25 19:37:18 EDT 2005 | Dave
Hi Mark, Check out Heller's white paper link for a study done with a PCB in line with thick and thin aluminum plates to measure repeatability and delta T with loads of large mass materials. The result was less than 1 degree with their oven due to i
Electronics Forum | Mon Dec 17 02:08:21 EST 2007 | mun4o
Hi, I have a lot of solder bridge in our wave soldering process.We use SACX0307 and Surf 11 flux.the SW mashine is Vitronics delta 6622.Itry to change flux and termoprofile but results is not god.Can you halp me - recommend me some flux or other adv
Electronics Forum | Mon Oct 19 09:59:30 EDT 2015 | cbeneat
I've never had that particular problem with our machine, but I do know that if the CB pop for whatever reason the machine doesn't give an error. So I would check those, if you haven't yet. Also under options you can do an element check, see if that
Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
Electronics Forum | Fri Sep 05 12:15:05 EDT 2008 | cyber_wolf
We have 5 ovens that we use this oil on. Its like $23.00 per pint from the manufacturer. But they say you have to buy a case of 24. I just went ahead and bought it from Vitronics.
Electronics Forum | Fri Mar 10 19:22:32 EST 2006 | bman
I hate to ask an obvious question, but are you sure all of your thermocouples are attached properly? I just can't imagine a 3X5 board having such a large Delta T unless it has some really odd parts on it. You sound like you know what you're doing,
Electronics Forum | Tue Sep 20 04:28:31 EDT 2005 | Rob
Pyramax 150 is a low cost newer version of the Paragon 150, the Paragon is a newer version of the VIP. The VIP is great for lead free (as confirmed to us by BTU, who told us it was pointless upgrading that particular oven to a Pyramax). You may nee
Electronics Forum | Wed Jul 11 09:11:07 EDT 2012 | cbeneat
To check the airflow for your exhaust, use a manometer. Testo makes pretty good low cost models. Your machine manufacturer should be able to tell you what the requirement is or it's in the manual under setup. If it's a Vitronics Delta wave, I can
Electronics Forum | Mon Apr 09 14:51:04 EDT 2018 | justconmac
UPDATE The reason for the board count in the wave when there are no boards is due to operators leaving racks with empty PCB slots. The input feed sensor is a little bit more in the center of the conveyor whereas the output feed is a slightly closer t
Electronics Forum | Tue Jun 30 14:59:54 EDT 1998 | Justin Medernach
| Looking to contact some users of Vitronics reflow ovens. | Which model do you use? | Overall opinion of equipment and company? | Thanks in advance I use an SMR500 without inert reflow, although it's capable. I have had great success with this oven
.gif)
