Electronics Forum | Wed May 21 15:52:24 EDT 2008 | samir
Wow RealChunks! What happened to that firey b#tchey Asian temper of yours? :-) Speak your mind and forever hold your peace! Here's what I know about Lead-Free Wave Soldering: 1.) Hotter pot 2.) Longer dwells Good info. on fluxes, by the way.
Electronics Forum | Mon Nov 21 06:49:57 EST 2005 | pjc
Go to this link for a nice tool for wave solder process troubleshooting: http://www.speedlinetech.com/news_publications/application-notes.aspx?OnId=5 Look for "Wave Solder Troubleshooting Wizard" If you have an Electrovert machine, contact applica
Electronics Forum | Thu Nov 17 03:34:51 EST 2005 | cangly
Hi, We have a board with over 100 chips (mixed size) and some long Connector DIP through out Wave solder with many issues of no solder and solder bridge, (using clean flux with bubble fluxer and Kester solder bar). Currently we tried to reduce the de
Electronics Forum | Thu Nov 17 20:23:14 EST 2005 | cangly
Hi Russ, We control the gravity of flux each 8 hours and will mix thinner to balance it if any.. Do we need more any action for this.. Thanks for your advices.
Electronics Forum | Fri Nov 18 08:31:09 EST 2005 | jdengler
This is way too long of a time. The SG probably changes significantly over this time. This could be a major contributor to your problems. Jerry
Electronics Forum | Thu Nov 17 08:57:39 EST 2005 | russ
No clean and foam fluxing is not a very good process from my experience. I know that the flux manufacturers claim that they are suitable but I am not sure what "suitable" means. I would bet that you have very inconsistant flux coverage. How often
Electronics Forum | Sat Feb 22 11:37:00 EST 2020 | kylehunter
Hey all, I've made a post in the past about us expanding to a new space, but I wanted to do a new post with specific questions. We currently have a DEK 265, Phillips Opal Xii, and a Heller 1500. Our main reason for expanding is to have a lead-free
Electronics Forum | Tue Nov 22 17:08:03 EST 2011 | mikenagle
I am looking for process suggestions. We want to use a pin transfer system to deposit adhesive to hold bottom side SMD's in place. We will place SMD's and through hole power parts on the top side and then run through a wave solder machine. Are ther
Electronics Forum | Mon Jun 21 15:46:00 EDT 1999 | Chrys Shea
I swear I posted it! I smoked an entire cigarette waiting for the damn thing to upload! I'll try it again when I get home tonight. Sorry for the inconvenience.
Electronics Forum | Mon Jun 21 21:14:16 EDT 1999 | Dave F
| I swear I posted it! I smoked an entire cigarette waiting for the damn thing to upload! I'll try it again when I get home tonight. | | Sorry for the inconvenience. | | | regular or filter?
.gif)
