Electronics Forum | Thu May 05 08:14:45 EDT 2011 | kahrpr
Where black pad exists, it is not a common problem. When I read it is totally random I doubt that. You have defiantly something going on that is unique with the process. It is either your board manufacturer or your solder paste or your profile. It c
Electronics Forum | Thu May 09 22:32:50 EDT 2002 | ianchan
Hi Guys, thanks to everyone for their help and advise! we are running these LCC parts in the 1000's, so its going to pose a big problem to either: 1) tin-plate the oxide layer, 2) HCL away the oxide layer, thanks for the option shown, dun think so
Electronics Forum | Fri Apr 29 14:16:16 EDT 2011 | ppcbs
Below is the long explanation. This defect is most commonly found with BGA components, but can arrise with all components. I see it happening more now with lead free boards that are being assembled with a no clean flux. Best short term remedy is t
Electronics Forum | Wed May 08 23:18:58 EDT 2002 | ianchan
Hi mates, have this SMT production issue : A) We have a leadless-chip-carrier(LCC) IC package that is classified under the Land-Grid-Array(LGA) package family. B) The LCC is 4mm x 4mm, and has 28 tin plated pads located beneath the outside perimet
Electronics Forum | Wed Sep 26 11:17:38 EDT 2012 | garym4569
We have been having a solder paste reflow issue which results in the solder not wetting to the LED lead. The solder appears to create "puddles" on the pcb pad. I have attached AOI image for review. We have had the pads analyzed for contamination, w
Electronics Forum | Fri Mar 23 03:41:19 EDT 2012 | grahamcooper22
try Almit Sn62 HM1 RMA V14L ....its the best no clean lead paste for wetting...I sell it and it has solved wetting problems many times when users have used other pastes
Electronics Forum | Thu Sep 03 04:53:31 EDT 2009 | d0min0
to summarize - 3 components are placed on a single module x 8 on pcb - 2 anodes & 1 cathode are infected (so no component for us) - the problem does not look like wetting problem as the component and land pad is wetted, but the paste is not complete
Electronics Forum | Thu Sep 03 02:38:00 EDT 2009 | sachu_70
Does the established joint still exist if once again re-touched by a soldering iron, or does it return to the original problem? Wetting issues on pad could be for many reasons and you could analyze with a cause effect diagram.
Electronics Forum | Tue Sep 01 11:30:28 EDT 2009 | rgduval
Is the solder wetting to the pad, and not to the part? If so, and all other things being true (same process, profile, solder), we'd suspect some contamination on the part preventing solder from wetting to the part. This could be tested by attemptin
Electronics Forum | Tue Sep 01 02:57:42 EDT 2009 | d0min0
davef As for the repair : - with hot air blower it is not possible (you can melt, but it will not wet) - with standard iron - no problem to repair (no additional material is needed) isd.jwendell yes, the profile is checked on those places (same si