Electronics Forum | Wed Apr 14 13:37:56 EDT 1999 | Mark Charlton
Can someone explain the difference between solder "fines" and solder balls? Is there an official specification where "fines" are defined? What is the spec for "fines"? I consider "fines" individual unmelted metal spheres that are found in solder
Electronics Forum | Wed Apr 14 12:46:38 EDT 1999 | justin medernach
| | | Thanks all you kind and knowledgeable folks. I no longer will be participating in this forum. | | | | | | After careful consideration, I have come to the conclusion registration, in the manner required to participate in what was an open forum
Electronics Forum | Wed Apr 14 16:37:47 EDT 1999 | Wayne Bracy
| | | | Thanks all you kind and knowledgeable folks. I no longer will be participating in this forum. | | | | | | | | After careful consideration, I have come to the conclusion registration, in the manner required to participate in what was an open
Electronics Forum | Fri Apr 02 02:01:24 EST 1999 | P.L. Sorenson - Technical Consultant
| | | Has anyone heard of a problem with catastrophic failure of | | | large value (200uF) solid tantulum capacitors that have been | | | exsposed to high humdity. | | | | | I suppose that with water moisture seep in the capacitor, the risk is ver
Electronics Forum | Fri Mar 19 19:05:27 EST 1999 | Earl Moon
Folks, I think we are getting closer to being very happy with DEK stencil printers of the 265 GSX variety. However, problems continue arising concering fine pitch autoflex tooling pin breakage. We are told by the British engineering establishment,
Electronics Forum | Thu Mar 18 13:54:30 EST 1999 | John
| Hi folks, | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and somet
Electronics Forum | Thu Mar 18 17:18:22 EST 1999 | Earl Moon
| | Hi folks, | | | | I am looking for inputs on a long-standing problem encountered in our shop: Bottom-side parts (passives) falling off in the Wave...where the only remnants of the part is a flattened glue dot of proper diameter and volume, and
Electronics Forum | Thu Mar 18 20:08:34 EST 1999 | Steve Gregory
Are you suggesting there may be some chemical incompatibility between paste/flux chemistries and the glue being used - thus intefering with the glue's ability to bond properly? I've only heard of this possibility, but never experienced it. Justin, St
Electronics Forum | Fri Mar 19 05:08:24 EST 1999 | Vinesh Gandhi
Hey Marc, I am not sure about the kind of process you are following. Is it Gluing+paste printing on the bottom side or just gluing on the bottom side and paste printing on the top side. The relationship which I could think of between Bottom side
Electronics Forum | Sat Mar 20 00:33:28 EST 1999 | Mike C
| We are having a small number (~2%) of our boards pass our manufacturing diagnostics, fail once they reach the customer, fail when they get back to us and then start working again after handling them for a short time. We have eliminated a lot of it