Electronics Forum | Tue Jan 11 16:38:18 EST 2011 | gosswald
JMW, Thank you for your reply. Can you add the upward camera to this machine that does not have it after purchase? If so what is involved? I do have typically two items per board that would be below 25 mil pitch.
Electronics Forum | Wed Jan 12 07:22:02 EST 2011 | jmw
To add the camera to the machine would have a lot involved......including possible software/firmware upgrade. I would say buy a machine that already has it on it. To find the parts and upgrade it would probably cost more than the machine is worth. Ho
Electronics Forum | Thu Aug 04 11:38:53 EDT 2011 | emeto
If you think it might be connected to Video card or RAM you can put a PC with better parameters. In my case the application dies with a standard Windows message.In the beginning I would blame the camera, but after that I realized it is doing it when
Electronics Forum | Tue Apr 26 07:37:59 EDT 2011 | leemeyer
Have you performed the camera to nozzle calibration ? I can send you instructions for this if you need them.
Electronics Forum | Tue Apr 26 10:14:06 EDT 2011 | leemeyer
The camera to nozzle offset calibration requires that you modify some of the mod codes once the offsets are calculated. This is not part of the VU3 calibration. Send me your email address so that i can attach a copy of the manual for you.
Electronics Forum | Mon May 09 16:32:05 EDT 2011 | veeckm
I got the camera nozzle offset corrected but after the machine runs for a while the offset will drift and its out the specs I set it to. Any help is appreciated.
Electronics Forum | Thu Oct 06 09:42:57 EDT 2011 | vetteboy86
I've put a call in for some tech support. I haven't had much succes dealing with them in the past. If anyone is running this machine, any knowlege on my problem is much appreciated. Currently camera 3 (highest magnification) will not find fiducials
Electronics Forum | Thu Dec 08 11:31:40 EST 2011 | comando
Hello every one! How I know if camera 1 and 2 are Narrow or Wide view in a Fuji IP3?
Electronics Forum | Tue Jan 24 08:01:32 EST 2012 | wolverine
When using the rectangular plate given with the machine that is used with calibrating the movable camera, does the longer side of the plate get fed into the machine ( rails set to 80mm ) or the shorter side ( rails set to 74mm ) Thanks Dave
Electronics Forum | Sun Jan 29 12:55:38 EST 2012 | tech_fun
i don't thing that it is a rule. the only ideea is to mov the camera exactly above the hole in the middle.