Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Mon Feb 25 22:57:31 EST 2013 | mdang
Hi Sr Tech, As you suggested, I tried with different AMP and it is display from 0 to 9 when I rotate the FRQ motor. I am going to replace the HPX-T1 AMP. Would you cut the wire or trace it to back to replace it? Thanks, -Michael
Electronics Forum | Wed Apr 24 12:54:36 EDT 2013 | smtventasmex
Hi i working now on electrovert omniflow 10 tha deos not control the speed of the conveyor on the sofware, i did change the encoder but this ones continue failing, this fail start because we have a short cut on smemma wire, any one have experience wi
Electronics Forum | Wed Jul 10 15:35:08 EDT 2013 | rgduval
In general, I've always considered solder paste a part of the overhead costs, along with wire solder, and other consumables utilized on the shop floor. It's a part of the cost of the assembly, but, I don't calculate it directly as a part of quotin
Electronics Forum | Wed Jul 31 13:19:38 EDT 2013 | anvil1021
Does anyone know how to test for hard gold on a PCB? We are in a challenging situation with a PCB provider and we need some objective evidence other than wire bond failure to present to them. Any comments could help ....Thank you Anvil
Electronics Forum | Wed Apr 16 16:58:00 EDT 2014 | jimmyboz
My first guess, loose wire or bad cable. Email me and I will send you a checklist.
Electronics Forum | Wed Jun 18 02:43:37 EDT 2014 | tjbooc
CHECK IO BOARDS STATUS, CHECK HEAD IO 24VDC SUPPLY, CHECK 24VDC SUPPLY TERMINAL, CHECK WIRING CONNECTED TO HEAD IO I think this is an I/O communication problem. Fail in connecting to I/O cards.
Electronics Forum | Fri Oct 03 04:24:54 EDT 2014 | dcarroway
Does any one have a wiring diagram for an electrovert Omni 10. We are having trouble finding why zone 7 runs over temperature.
Electronics Forum | Sun Dec 21 04:19:52 EST 2014 | leadthree
When I worked for a company that did alu-wire dice bonding they used a brand called Hysol for encapsuling. It needed heat cure. It's extremely hard to remove. As far as I remember it's epoxy based.
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.