Electronics Forum | Sun Jan 20 17:55:49 EST 2013 | ngineer
Mikej, I'm only running a single image, just want to correct for the slight variations in how the board seats in the transport. It's not more than a few mils off, but enough to cause an issue on fine pitch parts. I don't have any image fiducial
Electronics Forum | Fri Nov 09 10:02:46 EST 2012 | stiva
I have accuired a Novastar 1800A Reflow Oven, But no Documentation. I am trying to alter the profile of the machine, but cannot access the setup menu. The screen says enter the security code to continue. Does anyone know what the security code is for
Electronics Forum | Thu Feb 14 10:23:32 EST 2013 | vincent_qms
Hello, we have a DEK 248 just acted up with the squeegee orror. unit powered up initiated and when throght setup a job fine but when we started printing, the back squeegee came down, touched the stencil, stay for about 5 second then came back up with
Electronics Forum | Mon Mar 25 20:02:05 EDT 2013 | hegemon
Thats a good one Dave. Sorry to say, but I have seen setups very similar for the mass repair of Playstations. Just add a heat gun over the top and you are ready for some rework! . And just LOOK at the controller! With E-Z turn knurled knob for setti
Electronics Forum | Mon Jul 08 13:19:06 EDT 2013 | williamaxler
There are a lot of things that you need to look at to figure this out. What type of flux are you using? Is this leaded or lead free? Do you have the gradient of the nozzle setup properly? Are these locations tied to plains? With that being said
Electronics Forum | Wed Jul 24 16:12:39 EDT 2013 | tbouslog
I am looking for a poster (or anything) that shows Polarity Markings for different SMT Components. I would like something for SMT Operators and SMT Setup to be able to look at when training or when they are questioning the polarity of a part. If anyb
Electronics Forum | Wed Aug 07 16:06:26 EDT 2013 | rway
What type of filtering are you using? Your solder inspection should be using Histogram Inspection as the Decision and red filter for preprocess. Make sure your settings are correct and check your binarized image under Histogram setup. you should s
Electronics Forum | Wed Sep 04 11:26:17 EDT 2013 | srgbarba
Hi, I'm trying to implement SMED metric at SMT area in order to improve our change over (CO) up to 10min in high mix low volume process, ant at this moment the start and end point is the inspection before the oven, and what I'm trying to figure out i
Electronics Forum | Mon Nov 17 07:15:36 EST 2014 | garym4569
If you have feeders that you want to always stay on the same machine/position, enter them in the permanent data for the machine in the MSL setup. That is a simple way to reserve locations. Also, the optimization can use any common parts set in perm
Electronics Forum | Tue Feb 18 11:02:05 EST 2014 | cunningham
Thanks for the reply. Yes we currently have an Ionagraph setup at the bottom of the wash where we take the first board out for that day and check it for contamination. Im just wanting to get an idea if any jets are blocked and that the temperature