Electronics Forum | Tue Jun 08 13:06:53 EDT 1999 | Kevin Hussey
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Tue Jun 08 14:16:49 EDT 1999 | Dave F
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Wed Jun 02 07:23:04 EDT 1999 | Earl Moon
To you all for comment and summary, The following things I like without endorsing (PCB/PCBA stuff - outside the great women in my life [many] and without [mostly]): 1) A good set of design rules 2) A good set of design rules meeting producibility r
Electronics Forum | Tue May 25 10:56:12 EDT 1999 | John Thorup
| | | Can anyone steer me towards a supplier of heatsinks suitable for use on a PQFP 160. Before you shoot me down in flames, I know that I am not going to get much heat away from the die because of the plastic but the application is such that the bo
Electronics Forum | Fri May 21 15:29:26 EDT 1999 | JohnW
Joe.. Sound's pretty neat trick..mind if I ask what type of comp's are on this board and the paste..? This baby (pig I think) has got a 244pin QFP right dam in the middle..!, so if ur flipin it 180 degree's are u using like a piece of Jot in line co
Electronics Forum | Wed May 19 14:58:31 EDT 1999 | Wendy Casker
John, Thanks for the advice. I spoke with some of the connector suppliers apps guys today and they have what is called "European" style tooling which consists of top and bottom tooling. The board sits on rails and the Bottom tooling receives the pi
Electronics Forum | Fri May 21 15:51:49 EDT 1999 | JohnW
Wendy.. I found that little nugget a good one from my connector suppliers..Oh we have a tool to put it in for u..only catch was the one I needed was �37K ! ! after falling off my seat I went for something like what I described blow..cost about �1K.
Electronics Forum | Thu May 13 10:06:06 EDT 1999 | C.K.
| | I am looking for anyone who has converted over to VOC Free flux. I need some info on any problems, etc. that you might have had. | | | | Please E-mail me at wes.ruggles@vickers-systems.com or call at (513) 494-5229 | | | | Thanks | | Wes Ruggl
Electronics Forum | Fri May 07 02:29:16 EDT 1999 | Bob Willis
| | I would like to know if someone aleady have problems with Ceramic Capacitors SMD in In-Circuit Test (see below)and how did you solve this problems ? | | | | PROBLEMS | | 1 - Only one kind of capacitor (2n2F), of all capacitors on board, sometim
Electronics Forum | Thu May 06 09:24:06 EDT 1999 | Joe Manzur
Kevin, We are also looking at printing adhesive. Our application involves printing glue on the underside of the board, once it has gone through the dip, axial & radial process. In otherwords, there are leads cut and clinched and we have to mill out