Electronics Forum | Fri Jan 03 08:19:24 EST 2003 | emeto
hi, for more info try one of these if you missed some: http://www.amkor.com/ http://ap.pennnet.com/ http://www.asymtek.com http://www.smta.org/ http://www.semiconductor.net/ http://www.smtinfocus.com/ http://www.elis.rug.ac.be/ http://www.kns.com
Electronics Forum | Fri Jan 03 16:14:37 EST 2003 | Jacques Coderre
Hi Jon, Flip Chip is chosen as an interconnect approach when one needs improved performance (high pin count, high frequency, noise reduction or improved heat dissipation.Another driver is size...Flip Chip greatly reduces the area and therefore is cho
Electronics Forum | Wed Jan 09 17:14:48 EST 2002 | mregalia
Do you bond with Al or gold wire? What happens if the Ni is over 150 microinches? Thickness of nickel is one those things that we have not been consistent with. The industry seems to pretty much universally call for 100-200 microinches. Our old board
Electronics Forum | Fri May 29 07:17:02 EDT 2015 | anirudh_thabjul
Hiee everyone, I am a Hardware Engineer and also a PCB designer. I am using a Microntroller which is in "CHIP PACKAGE". So in order to connect our microcontroller with my PCB, i am using "Wire bonding Technology". So, Can any one suggust 1. whi
Electronics Forum | Tue Nov 15 21:06:04 EST 2005 | davef
Is your IMC purple? [The sure way to tell if you have the 'purple plague'.] Where does the failure occur? * At pad / wire bond * Up wire from the bond Tell us about the aluminum pad. * What is the plating specification? Is that what you actually r
Electronics Forum | Tue Nov 15 12:21:20 EST 2005 | arclightzero
Well, I can't speak for them falling off later on, as that's not when I see them, and they are passing their wire pull tests after bonding. What I am seeing is electrical opens during testing, and these opens coincide with the Au/Al bonded points. Th
Electronics Forum | Tue Nov 15 09:31:27 EST 2005 | arclightzero
I have been reading a good deal about IMC (purple plague in particular) in gold wire/aluminum pad wire bonds. My company uses ultrasonic wedge bonding, and for the most part all of our bonding is gold/gold, however we have one particulr part that has
Electronics Forum | Tue Jul 18 16:49:49 EDT 2023 | mahasg
Hello All, I am PhD student at polytechnique Montreal. We have a CQFP44 packages and Dies of 51um pad pitch (22nm FDSOI tech) that I need to bond myself at the university using ASM Eagle Xtreme gold wire bonder in the university. we need to perform b
Electronics Forum | Wed Mar 25 09:01:09 EST 1998 | Harvey Grossman
What is the recommended finish for wire bonding ? Type of AU, thickness, etc. thanx...
Electronics Forum | Sat Jan 21 12:18:53 EST 2006 | theSaint
What is wire bonding? What are the applications?