Electronics Forum | Wed Nov 07 10:59:55 EST 2001 | paulburt
Hello all, I have been tasked with bringing my company up to spec with J-STD-033, yes lucky me! My question is this: While I was searching the Web for suitable suppliers of dry cabinets I came across a company advertising a humidity control system f
Electronics Forum | Thu Jan 03 08:01:23 EST 2002 | davef
In addition to a previous poster's comments, you many want to understand moisture sensitive components better. Start with: * J-STD-020 and J-STD-033. Download them here: http://www.jedec.org/download/default.cfm * �Moisture Sensitive Components� R
Electronics Forum | Thu Apr 25 09:27:03 EDT 2002 | fmonette
Michael, This concern is well covered in J-STD-033, section 8.6 Board Rework. "...If the component temperature exceeds 200C, the board may require a bakeout prior to rework..." In other words, you only need to worry about moisture related defects w
Electronics Forum | Thu May 16 11:37:13 EDT 2002 | fmonette
My company offers a simple and cost effective control system for MSDs on the factory floor. It is a turnkey solution to comply with J-STD-033. If you want more information feel free to contact me offline. Francois Monette Cogiscan Inc. Tel : 450-53
Electronics Forum | Thu Mar 20 15:12:01 EST 2003 | fmonette
Hi Carol, You can find many complete articles on the subject of MSD Control in the MSD Knowledge Base on our web site at http://www.cogiscan.com Do not hesitate to contact me directly if you have specific questions. My company is an active member
Electronics Forum | Thu May 20 09:29:02 EDT 2004 | Dilbert
Three LEDs, 3.5volts @.02amps each is 10.5volts. You said you calculated out an 82 ohm resistor so 82 ohms * .02amps is 1.64volts, I guess your going to use a 12volt supply. P=I*E =.02amps * 1.64volts =.033watts so a .25watt resistor will be fine
Electronics Forum | Tue May 18 17:07:18 EDT 2004 | gabriele
Wave Solder temperature should not cause problem to MSDs. Just in case on PBA there are very critical MSLs (ie. 5 or 5a, 6 (?!?) try to detect what is the max temperature on such MSD bodies and how long they stay under such temperature. But it schoul
Electronics Forum | Wed Jun 23 19:44:58 EDT 2004 | kennyg
J-STD-033A specifies a 1 year exposure life for moisture sensitive level 2 components, but no baking temp/duration for anything less than a level 2a part. Although the need is rare, what does a person do to dry a level 2 part that has been exposed f
Electronics Forum | Thu Sep 02 11:00:14 EDT 2004 | diderry
Hi Bryan, I hope you dont mind a quick sales pitch here. We have developed a system called HumiTel which is used to manage MSDs. Its not the paper tracking system you mentioned; it comes in two flavours, a hardware tracking device and a software whic
Electronics Forum | Thu Sep 15 22:23:36 EDT 2005 | davef
Use your board supplier recommendations Specific procedure or guidelines that need to be followed for handling Moisture Sensitive Devices => J-STD-020 & J-STD-033 Is there any paste height/volume requirement for a lead-free process? => You need to