Electronics Forum | Mon Aug 06 18:29:33 EDT 2012 | spoiltforchoice
I would guess a small US/Europe CEM with modest equipment could probably get the assembly cost somewhere close to $15, the volume is large enough that tooling charges may well be irrelevant. Such a CEM might appreciate the freedom to source the parts
Electronics Forum | Tue Aug 07 07:06:10 EDT 2012 | jdengler
Joe, If you order and take all 1000 boards in one delivery you should be in the $6.00 to $9.00 range for labor only. Jerry
Electronics Forum | Tue Aug 07 08:46:21 EDT 2012 | joefosho
Thanks for the replies everyone. I was hoping the cost would be under $10, and it looks like that might be possible. Time to start designing! Thanks, Joe
Electronics Forum | Thu Aug 23 15:53:20 EDT 2012 | diamondmt
Joe, While designing the LED panel, will it be used outside or inside, have to taken into the account that use of conformal coating to protect this LED panel from possible moisture penetration into the unit?
Electronics Forum | Fri Aug 24 16:17:56 EDT 2012 | joefosho
This is going to be for indoor, home use. So I don't think I would need anything like that.
Electronics Forum | Wed Sep 19 13:14:49 EDT 2012 | proceng1
Make sure you put fiducials on each board in your design. It's very frustrating to get a simple SMT only board with no fiducials and I need to use inconsistent board features to program the pick and place.
Electronics Forum | Mon Aug 25 20:14:35 EDT 2014 | nhel_0009
Yes sir we're using tray elevator..but i'm thinking with manual tray for another options.thank you
Electronics Forum | Thu Sep 22 13:25:34 EDT 2016 | chabscan
Thank you so much, Bob, I will be asking for more asistance in the future, since I am new to this technology, regards
Electronics Forum | Mon Mar 12 13:56:06 EDT 2018 | proceng1
Oh I know it's BS. It's not like the mesh belt creates a barrier between top and bottom. There is very little delta from top to bottom. Whenever I see a recipe with different temps from top to bottom, I just delete it.
Electronics Forum | Thu Jan 19 04:35:35 EST 2006 | pavel_murtishev
Good day, I worked with Maratnz some time ago. My own opinion is that this is limited machine with limited functions. Main disadvantages are: - Rather costly, something about 100 KEUR per table top machine; - 2D scanning system (direct light module