Electronics Forum | Sat Feb 05 14:51:49 EST 2005 | etienne
One important thing to look at, when buying an AOI is the False Calls Rate, along with tact time of machine to inspect the PCB. Obviously, many machines can do the the work....but it's also true that each machine differ from the way it do the work. S
Electronics Forum | Wed Feb 09 12:31:54 EST 2005 | russ
We are not doing this right at the moment but I have done it with great success. Of cource it depends on your pad layout we have a 20 mil gap in between pads, we printed at 10 mil wide with a 5mil stencil. I will try to find the glue we used, I kno
Electronics Forum | Wed Feb 16 21:26:11 EST 2005 | Mrduckmann2000
Well, I have not had a chance to run my experiment yet. I hope to have the wave solder machine to myself on Friday morning. I will let you know. I am hopefull from what you and the others have said that it will work and we can reduce our touch lab
Electronics Forum | Fri Jan 27 15:39:08 EST 2006 | GS
Thanks Patrick yes I feel better now, but allow me a comment: Reason A: your answer confirms my tough. In general could be accepted Reason B: your answer "The primary function of ups start when electricity is "off" so the equipment is clearly exem
Electronics Forum | Fri Jan 27 16:50:22 EST 2006 | patrickbruneel
GS I am not a lawyer and the European directive has a lot of grey areas. But if you look at 1.2 in the link I send you it states that when an appliance can still function when the electrical current is off this type of equipment is not covered by di
Electronics Forum | Wed Mar 12 12:28:52 EDT 2008 | operator
I recently witnessed a process in which the solder pot operator used Techspray WSOL water soluble masking to cover the areas around a connector that was to be soldered on the solder pot. He did not wait for the WSOL to cure. He soldered immediately.
Electronics Forum | Wed May 07 10:15:46 EDT 2008 | llaerum
We are also having some issues with certain small parts. In our case this is tantalum caps and 0402 caps. We had a vendor admit after much discussion that the plating used from a particular orgin was different on the tantalums. The tehory is thatthsi
Electronics Forum | Wed May 20 17:56:51 EDT 2009 | dyoungquist
I have attached a pdf showing the dimensions for the QFN we placed. First, The pins on the part are not only on the bottom side but also wrap around to come up each of the 4 sides of the part as shown in the side view in the attached pdf. This i
Electronics Forum | Fri Aug 29 04:33:52 EDT 2014 | mun4o
Hi all, we have 2 smd line with 2 topaz x|| each.The machines are 10 year old.Now we need more capacity and I am looking for new line.Because there is not space for third line , we must change the p&p with more productive machines.I like Yamaha , an
Electronics Forum | Tue Sep 29 11:49:02 EDT 2015 | spoiltforchoice
Typically - hand soldering as you are currently doing. Should your volume justify it you can invest in a selective soldering solution, these might take the form of a robotic arm that essentially replicates manual soldering or a solder jet similar to
