Electronics Forum | Fri Feb 16 11:07:25 EST 2007 | stepheniii
I'm not sure if anyone mentioned the single most important factor. p.m.'s. If the nozzles are getting dirty and clogged it's not going to do a great job of picking parts up. Don't think in terms of variation. It's there it's unavoidable and undet
Electronics Forum | Thu Dec 21 13:11:25 EST 2006 | SWAG
We have fought with cut-tape way too much. It's always a bad idea. We've tried a couple methods/devices for manual splice with limited success. Before you look into this I would ask them if they could supply you cut tape qty's inslusive of fairly
Electronics Forum | Thu Feb 19 13:39:51 EST 2009 | tedel
Yes, I called Fuji as well!! I guess we're all in the wrong buisness... Received a reply from Biral Lubricants in Norway, they state the following... "We have established our own warehouse in St.Petersburg, Florida and handle presently all inquirie
Electronics Forum | Fri Mar 14 11:25:02 EDT 2008 | hegemon
ol' hege has got to agree with Chunks and Dave. Seems every time there is a problem, the finger is first pointed at the process. For my $.02 it doesn't matter if your process is 100% bulletproof, procurement will screw it up by finding a vendor that
Electronics Forum | Mon Oct 15 10:51:49 EDT 2001 | davef
On over printing, the general issues are: * Paste deposits being so large that when reflowing, collapse onto many, rather than a single solder mass. * Paste expanding during heating and being close to other solder deposits and bridging [as you say].
Electronics Forum | Wed Mar 25 18:34:34 EDT 2020 | spoiltforchoice
> What about designators? Using gerbers to program > a pnp machine was always a last resort to be done > only after much complaining and begging for > proper CAD data. Back in the day I used UniCAM to > program a mydata. After gett
Electronics Forum | Wed Aug 21 17:44:32 EDT 2002 | davef
Splitting hairs, I expect SIR of all solderability protection, including OSP, to decrease after reflow. What�s more, I expect the SIR of all solderability protection to pretty much decrease over time. The �comb pattern� test specimens meet requirem
Electronics Forum | Sun Aug 26 12:40:59 EDT 2001 | stefwitt
I would like to enter the discussion by tossing some numbers in. First of all I don�t like the 3 Sigma value. 3 Sigma are 2000 defects per mio. if I remember correctly. This means, if you have 200 components on the board, then every 10 boards have on
Electronics Forum | Mon Jan 07 02:36:31 EST 2019 | sarason
PCBSynergy can program a DDS Novastar https://pcbsynergy.com Its labeled APS Novastar on the manufacturers list sarason
