Electronics Forum | Tue Sep 18 08:14:31 EDT 2007 | jeffharley
This would not produce the condition that Darron is seeking help for as the vcd would stop due to not seeing a clinch in signal with a mechanical jam.
Electronics Forum | Fri Oct 02 12:57:13 EDT 2009 | dnebel
Looks like you'll need to reset the controller. That will require turning the Run/Halt swith to Halt and back to Run. That should put an @ prompt on the screen. There is a list of inputs you continue through to reinitiate, but I have forgotten the
Electronics Forum | Mon Oct 05 08:32:11 EDT 2009 | jeffharley
Make sure you have DC ok light on, on the EMI/PS card slot one. If not check your DC voltages at the card...5,15+,15-,12 v dc. if your voltages are not there then the machine will not run.
Electronics Forum | Thu Oct 08 21:29:31 EDT 2009 | stevezeva
I don't think NEA is around anymore. I know of a great guy named Don Burshnick at a place called SMT Technologies that used to build Universal machines and knows them like the back of his hand, call him at: 607-772-2900. Steve
Electronics Forum | Tue Oct 13 08:49:09 EDT 2009 | kudamarani08
try "halt" your EMI and check if the @ appear on screan. If yes, type G or P to re-start the system. If NO, make sure 5VDC is present. V2 controller really a tricky one.
Electronics Forum | Tue Oct 13 19:15:59 EDT 2009 | fulldrawmike
if you have not turned the halt switch down then back up you can sometimes get a restart using 0(zero)G and enter. If that does not work you will have to load the exec.
Electronics Forum | Fri Oct 23 09:05:04 EDT 2009 | kircchoffs
Hi Guys, can anyone recommend a good and reliable prep machine? that can also perform trimming and forming for axial and radial components. our plant is located in philippines. thanks in advance
Electronics Forum | Wed Aug 11 14:45:46 EDT 2010 | davef
Yes, it OK to mount axial PTH component as radial PTH, if that's what you're asking. * There are no rules for orientation. Pick something and stick to it. We like to be able to read the component value / orientation from the top towards the board.
Electronics Forum | Fri Apr 13 04:21:40 EDT 2012 | JB
Turned out to be just a axial 2A fuse on the MVME162-220 CPU card. Cheap repair in the end.
Electronics Forum | Sat Sep 01 10:46:22 EDT 2012 | davef
Years ago, we almost bought a Manix axial lead former / trimmer, but found a used Hepco at the last hour and went that route. I can't remember, but as I recall, we wanted to be able to do standoffs and there was some issue on standoff tooling with on