Electronics Forum | Fri Dec 16 11:31:45 EST 2005 | fastek
Does this bring back some awful memories! Back in the mid-80's I worked for a little company called Solectron (yes they were small back then). They wanted everyone to wear smocks and I fought that one come hell and high water. It was all for show as
Electronics Forum | Tue Jul 04 03:15:00 EDT 2006 | dougs
can't you pull the leadscrew cover back? you usually can on fuji machines. pull it back and clean the leadscrew down then smother it with grease and manually run the axis back and forth a couple of times. then repeat until the grease is not discol
Electronics Forum | Thu Aug 31 16:18:30 EDT 2006 | GS
I beg you pardon AR, I made a mistake by reading your request, you are looking for a service lab who can do the peel back force test and not the Reference Standard (like EIA-481) for T&R. You should check if in your Country some Tape and Reeling Serv
Electronics Forum | Fri Aug 03 02:18:41 EDT 2007 | cadcopac
Hi Steve, I agree with Darby on this your poor operator will be walking a mile a day!!! but if you absolutely want them on the back try this .... in your components listing set the feeder position for all your vib components to a number between 100
Electronics Forum | Mon Aug 06 13:05:19 EDT 2007 | gemengr
Try this... set them on the back and teach their pick up position as stick feeder, change pick up rotation to -90 degree. before you optimize the program, change them to 8mm feeders , them optimize the the program as feeder fix. after the program
Electronics Forum | Thu Dec 05 17:59:14 EST 2013 | hegemon
By hand, we apply a precision die cut plastic protective film to a particular "lens" product. It is of the "peel the backing off and apply" style product. Due to the ESD event possibilities, this application is done in an area far away from any ele
Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Tue Feb 01 19:02:48 EST 2022 | proceng1
USC PArk is your underside stencil cleaner. The camera pushes it back and a magnet grabs it and holds it back. Ours did this many years ago. I pulled the rear cover and initialized the machine, when the camera pushes the stencil back, grab it and
Electronics Forum | Mon Nov 27 17:31:34 EST 2000 | Dave F
Send the boards back the fabricator and have another set made by someone else.
Electronics Forum | Mon Aug 14 09:21:15 EDT 2000 | John Thorup
look back to August 3 for a thread on this
