Electronics Forum | Sun Nov 07 21:00:15 EST 2010 | mainenetservices
sounds like its probably a timming belt. stock drive products is the place i go for robotics mechanical stuff, They likely have a sutable belt if you can get a good mesurement on everything(mesure the pully teeth, the belt may be streched). https://
Electronics Forum | Tue Feb 07 01:54:45 EST 2012 | ngineer
What Should I use to clean a sticking conveyor belts in my pick an place machine (Quad IVc)? The belts seem to have what I would guess to be solder paste that is dried, but also they seem to be a bit gunked up as if they had gotten some oil or greas
Electronics Forum | Wed Jun 12 14:36:15 EDT 2013 | rollon65
Hi Bert I had belts made for my conveyors using Habasit material made by Benson's belting here in U.K. They have been running now for 6 years or so and I am very satisfied with them. We are 12K miles away but check out their website at http://www.
Electronics Forum | Fri Apr 28 02:10:19 EDT 2017 | bukas
i'd say its a ball nut. maybe it came loose or the balls are worn out. also, check timing belt! if resonance is periodical like you say then there is great probability that belt or/and belt pulleys got worn out. i had combination of these on one of m
Electronics Forum | Mon Jul 08 11:26:04 EDT 2019 | daniel_marquette
Swaping Y amps from a correctly working QSP-2 to this QSP-2 did not change anything: belts still vibrate. However, belts are in good shape, tension has been adjusted and bearings are turning free without play. Will try to swap Y motors from a corre
Electronics Forum | Fri Jan 06 09:39:35 EST 2023 | micropak
In newer machines, after changing a motor you have to do an "Axis Home Calibration". Once I changed Z-Axis belt on an SM-482 and it refused to successfully do "Axis Home Calibration. Then the solution was to remove the belt, rotate the motor pulley a
Electronics Forum | Thu Jun 13 08:53:25 EDT 2013 | markhoch
Ahhh yes. The infamous round rubber belts used on the Fuji CP2's and CP3's. :) I remember fondly using a pair of dykes and a Bic Lighter to make my belt repairs. Does anyone know if these are still available from Fuji? You may be able to find repl
Electronics Forum | Mon Jun 22 16:34:14 EDT 2020 | stephendo
What I have seen used are belt driven roof mounted exhausts. There would be a drum fan that is driven by belt and motor. That way the fumes never go over the motor or the belt. We would have to replace the belt every couple of years or so but then it
Electronics Forum | Tue Feb 29 15:43:14 EST 2000 | jacob lacourse
Hello, I was looking for a few companies that make belt feeders for pic and place machines. This feeder will have to compatible with a quad machine. Thank you