Electronics Forum | Sun Jan 27 17:59:25 EST 2019 | bobpan
The y-axis on that machine is left to right. If this is the axis you are having a problem with....check the motor. I have had to tighten the tension on it before. If you notice you lose steps after running for a while then this is going to be the iss
Electronics Forum | Fri Feb 01 07:11:07 EST 2019 | bobpan
x and y are the same...just change switches. t and z are the same...just change switches. The voltages on the cards are different(x/y same--t/z same)....i do have a procedure somewhere that allows you to make an x/y card into a t/z card. good luck
Electronics Forum | Sun Feb 03 09:36:29 EST 2019 | bobpan
Good job.... Sorry i didnt see this post...some of us were busy snow tubing over the weekend...haha. Many times over the years....the rubber belt inside the feeder will deposit material inside. Sometimes it ends up on the sensors and blocks the ligh
Electronics Forum | Thu Dec 21 11:50:55 EST 2023 | bobpan
Not many people use the vision on spin failure for 0402 parts. I would focus on repeatably picking the part from the feeder. If you insist on using vision then maybe you can take a permanent marker and darken the nozzle tip. Dont use a sharpie as it
Electronics Forum | Wed Aug 10 20:49:27 EDT 2005 | bobpan
Quad/Tyco should have some old 'q-tips' on programming help for that type of board on a 'c-series machine'that i wrote a long time ago. I cant remember anymore exactly how to help you but they should have some paperwork on doing it. It also is a 'sli
Electronics Forum | Mon Jan 21 06:04:12 EST 2013 | bobpan
Some things to try.....keep in mind it has been over 10 years since i programmed one of those machines. 1. Tep Vision is what you should be using. I think it was called tep vpass in older software. 2. Maybe try goto 0 instead of goto 1. 3. Make sure
Electronics Forum | Wed Sep 12 06:13:22 EDT 2012 | bobpan
Glad i could help.....now this is a little harder....been a long time since i have done comp. fids and i dont have a machine to test....but check these things... 1. In the teach menu.....there is teach component fiducials. Make sure you do this with
Electronics Forum | Wed Dec 20 13:45:08 EST 2023 | bobpan
I dont know what kind of feeders your using for 0402 but it matters. It must be repeatable. It also sounds like your feeder z height is wrong. Test pick on the feeder and change the z until it just starts to pick it up and your z will be set. One oth
Electronics Forum | Thu Aug 16 07:40:27 EDT 2012 | bobpan
Here are a couple of things to look at. 1. Watch the machine run....and if it misses a part....make sure it doesnt blow out the next part being presented. Sometimes the air pressure is too high and the vacuum verify will blow the part out of the poc
Electronics Forum | Thu Mar 02 04:47:24 EST 2006 | bobpan
If you have an older machine that has cyberoptics you might want to try to put a pickup theta of 90. I believe there was a problem with that type of part. Also use non-leaded alignment and scan the part near the top of it. As for 0402 parts.........