Electronics Forum | Mon Oct 29 18:21:43 EST 2001 | slthomas
We recently have received a lot of warped (bowed and/or twisted behond IPC 600 specs.) bare boards (some our fabricator's fault, some ours by design) and I can't help but figure that long term reliability will suffer when building product with them.
Electronics Forum | Thu Nov 19 10:24:14 EST 1998 | Brian Co nner
Currently, I am having problems with a AMP Mictor connector at the wave process. These connectors have both SMT leads(topside) and thru-hole leads. Even though we have re-designed the board for via issues. We still see some of the SMT leads re-fl
Electronics Forum | Wed Jun 26 21:05:15 EDT 2002 | ianchan
Hi Dave F, customer calls it "warp", we can call it "twist/bow"..etc. the "warp" occurs on individual PCB cells of 28per each panel. the overall dimension of the panel is 139mm x 168mm, and each individual PCB cell is 2.4mm x 1.2mm. Thickness is 0.
Electronics Forum | Wed Jan 20 14:21:54 EST 1999 | Dave F
| I need some opinions (And I know everybody has one). | I am mounting a board into a case, after mounting the board | I am loading it with stress in the middle causing it to bend around .030 inch. The board is 4" X 6" and is Bending in the 4" dire
Electronics Forum | Tue Dec 17 20:25:13 EST 2002 | iman
Check : 1) design aspect ratio / are ratio required to fabricate the stencil you r using. 2) check if the stencil maker is using your checked aspect ratio / area ratio? if not the same, what are they using? any QA report confirming actual dimension
Electronics Forum | Fri Apr 16 17:19:59 EDT 1999 | Dave F
| | Hi, | | I just cheesed my previous attempt at this. I looked through IPC 600 and couldn't find anything relating to dimensional stability of a board with regard to stretch. I found bow and twist but nothing on size. I have a PCB that is .030"
Electronics Forum | Mon Jan 12 02:29:13 EST 2009 | sachu_70
Hi Milan, One cause for such BGA failures could either be a laminate warp (bow or twist) formed during your Reflow or Wave soldering process, or perhaps a warp seen on the BGA component package itself prior to processing on SMT line. IPC guidelines f
Electronics Forum | Mon Apr 19 10:14:12 EDT 1999 | Justin Medernach
| | | Hi, | | | I just cheesed my previous attempt at this. I looked through IPC 600 and couldn't find anything relating to dimensional stability of a board with regard to stretch. I found bow and twist but nothing on size. I have a PCB that is .0
Electronics Forum | Wed Jun 03 07:02:25 EDT 1998 | Earl Moon
| Does anybody know if a contraption exists that will minimize a PCB's tendency to become slightly bent after reflow? We have a new product that we're planning to assemble in a couple of months. The board is 9.7" by 13.4" and it is imperitive that
Electronics Forum | Thu Aug 10 13:12:10 EDT 2000 | Bob Willis
You may care to review the following from my Circuits Assembly page on line. "HOW FLAT IS FLAT AND DO WE NEED FLAT CIRCUIT BOARD, YES WE DO ? As production problems go there is one that keeps reoccurring time and time again. The blame is usually di