Electronics Forum | Thu Sep 26 05:23:51 EDT 2013 | bobpan
Does the original 'bad' SRX card work in the other machine? If so....then both boards are good and you have another problem. I would go through the list i posted above on motor error 4 problems. I would suspect a ribbon cable or motor/motor cable at
Electronics Forum | Thu Jun 02 08:45:41 EDT 2016 | emeto
If it is intermittent it is definitely cable or connector. Check all connections first and if not, replace the cable that is moving/bending.
Electronics Forum | Tue Feb 07 08:13:58 EST 2017 | fuji_user_2014
Looking for recommendations on drop ceiling busway/raceway to neaten our cabling. It is intended for a surface mount line with varying power requirements, data/com lines, and air drops.
Electronics Forum | Tue Mar 06 09:45:06 EST 2018 | optimatech
When it comes to PCB assembly services, you have to look for manufacturing, testing, cable assemblies, cable harnesses, and more. When you are in need of PCB assembly services and want to avoid all hassles, contact Optimatech and sit back and relax.
Electronics Forum | Fri May 11 05:30:35 EDT 2018 | bukas
and during that normal maintenance did you move motor cables and connectors? or motor controller board cables/connectors? you need to give us some more info on what you did there...
Electronics Forum | Wed Feb 06 06:14:01 EST 2019 | youngbuck
Try changing conversion board. 2 big ribbon cables plug in to it. p./n 00321189. or the 2 ribbon cables may need to be reseated. Thanks, Ryan
Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Feb 16 21:51:15 EST 2024 | jborrelli76
I was correct...the cable that operates the stencil clamps on the right bank is severed...do you know where I can get a replacement cable part number 163368? Thanks.
Electronics Forum | Fri Apr 30 01:11:00 EDT 1999 | Dean
| We will be moving our entire plant in a couple of months . We are in the process of installing communication cable etc, to allow for a easy drop machine in line type move. ( is this possible) | My question is what type of communication cable would
Electronics Forum | Sat Sep 30 10:04:39 EDT 2006 | daxman
I found this pot, and tried adjusting it. It was already turned to its maximum, and the histogram did not look good. I tried replacing the board lamp and this helped the histogram a lot, but I am not able to get the bars centered in the green. The