Electronics Forum | Sun Jan 26 09:32:55 EST 2003 | davef
But soon after cleaning and drying with IPA, we find a white residue formation. A: IPA will not nothing to clean your board. The white residue is exactly what you should expect. Search the fine SMTnet Archives for background. >How do we avoid th
Electronics Forum | Wed Jan 27 21:02:53 EST 1999 | Dave F
| i am working with the noclean process and getting white residues on the bottomside of the board probably due to the | wave soldering flux.i am using a no-clean solder paste and a noclean wave solder flux.The boards passed the accelerated temperatu
Electronics Forum | Fri Jan 05 09:23:10 EST 2001 | Brian Toleno
While there may not be any specific requirement to cleaning prior to coating, cleaning an assembly prior to coating will only serve to increase the reliability and integrity of the coating. Some residues from low-solids fluxes can interact with conf
Electronics Forum | Fri Jun 22 11:09:01 EDT 2007 | realchunks
Sup G! Normally when spray fluxers get neglected, the spray pattern is the first thing affected. To actually 'see' this, we cut out a piece of cardboard the same size and length of the board. Run it over the fluxer and then turn itover and look at
Electronics Forum | Fri Feb 24 02:04:50 EST 2017 | soldertraining
Selective Soldering Frames can pull large amounts of heat from the solder wave at the point of contact, effectively lowering the temperature of the solder at the solder joint. You should confirm the temperature of the solder joints by running a therm
Electronics Forum | Tue Oct 27 16:11:36 EST 1998 | carl m
| | | | What are the key feature to look for in buying a profiling product for Reflow ? | | | | | | Who's is the best and how much do these systems cost ? | | | | | | Thanks in advance. | | | | | | Hi Mark, | | | | I am currently the oven secto
Electronics Forum | Mon Aug 28 15:34:19 EDT 2000 | Steve Harshbarger
Hello Ramon, This is a very common problem that usually can be overcome. Can you tell me the flux type you are using (manufacturer, and flux number)? Has your board vendor, or type of PCB's changed (are they entec coated - bare copper)? What is t
Electronics Forum | Mon Oct 11 12:24:07 EDT 1999 | John Thorup
| | Folk's, | | | | I'm just tying up some loose end's on my Master's Thesis on solderballing @ wave soldering and the effect the topography of the mask / PCB has on it. | | I was wanting to do a straw poll on you guy's as to the type of resist's yo
Electronics Forum | Mon Dec 22 16:02:22 EST 1997 | Justin Medernach
| what is your experience about the presence of the voids in the joints ? | Are they dangerous and when ? Vincenzo, Voids in solder joints can be caused by a number of factors. Let's begin with the flux vehicle in your soldering media. If the prope
Electronics Forum | Fri Dec 15 15:59:35 EST 2000 | Hussman
Dave, It will all be about the same - changing atmospheres does not affect your heater output. You may experience some differences in the way your solder joints look (a little duller), but with some of the newer pastes out there, you can overcome i