Electronics Forum | Mon Jun 03 21:48:09 EDT 2002 | fastek
I judge a country's technology level by what they buy and what China is buying are not MSR's and CP-7's. It's MV2's, MV2C's, CP-4's with an MV2F here and there. If that's not behind the curve, I don't know what is. I would say they are 5 years behind
Electronics Forum | Thu Jun 27 02:52:54 EDT 2002 | Darby
Take a peek at a Samsung CP45v before you make a decision. I'm running two before a CP40v. Runs very well. Clever software. Cheap. I'm also running two Tenryu/i-Pulse FV-7100 in line vintage 1999. Great machines but it may be some time before the sup
Electronics Forum | Tue Oct 15 11:41:46 EDT 2002 | caldon
Yes i was joking about the resume thing...Some of you knowing me and my strange sence of humor will catch my "digs". My Mug held high........Any time... Hey is it possible to get a SMTnet meeting reception together at APEX??? Just a thought. This
Electronics Forum | Mon Oct 21 13:12:38 EDT 2002 | pr
Try a "cross" design across the problem apertures. So you wind up with 4 smaller deposits on the PCB (instead of 1 big one) but should be enough to hold the component. It worked for us and was much easier on the blades (they kept catching on the far
Electronics Forum | Thu Nov 14 09:24:07 EST 2002 | joconnell
What about when debugging the board I recently saw a case where we damaged a board between - 5-10 cycles of the fixture It's a catch 22 - where you need high force probes to breal the OSP - but the copper is hard surface, not like the solder HASL a
Electronics Forum | Mon Nov 03 16:58:05 EST 2003 | Bill
We are having a few problems with one of the tanks --possibly a drain clog issue. It is full enough to drip over. I'm waiting for a non-production opportunity to take it down and look under the catch screens. This is the lowest cascaded tank in
Electronics Forum | Tue Apr 27 14:54:26 EDT 2004 | Kirk
reduction apertures in stencil and question how find center?. I thought that vision start playing important role at the beginning for the first PCB, help set precisely printing process. You gave tip to work without Mylar. Ok but again how you set ste
Electronics Forum | Tue May 04 14:27:32 EDT 2004 | michasm2
Both are acceptable methods. - Printing on the board may give your operators a better ability to catch insufficient solder due to poor release; however if done right, printing directly onto the BGA ball is much more efficient and eliminates any compo
Electronics Forum | Sat Apr 30 14:12:50 EDT 2005 | thaqalain
Yeh,u catch my fault.Thanks Is it called Wave Soldering?how and why this name? I did'nt differentiate b/w two rods and in panic may tried wrong sequence of events.Word "wiggle" meaning is to proceed with or as if with twisting and turning movements
Electronics Forum | Fri Oct 07 14:59:07 EDT 2005 | gregcr
Hi Jimmy, We use flat belt exit conveyors. They are set-up to collect the boards and set off an alarm when the belt is full. This allows the boards to come out, but you don't have to pay someone to stand there and catch each board. Also eliminate