Electronics Forum | Mon Sep 21 03:52:17 EDT 2009 | darrenj
Found the problem. A small part had previously fallen off the nozzle, and ended up behind the left centering jaw preventing the jaw from opening up fully. Cheers Darren
Electronics Forum | Mon Jun 13 01:38:59 EDT 2011 | kenneth0
Hello Steve, i think you are experiencing the potato chip effect, where temperature difference at the center and edges are huge; causing BGA edges to tilt down or up.Try narrow down the temperature difference between the center of BGA and corner. I
Electronics Forum | Thu Aug 14 13:49:26 EDT 2014 | dyoungquist
Motor control MSETDYN -> Initiate axis C -> Centering jaws 156 -> Motor timeout Did not reach specified position Hardware problem Looks like you have something wrong with the movement of your centering jaws.
Electronics Forum | Fri Oct 17 09:38:07 EDT 2014 | rgduval
Are you able to turn off mechanical centering? Or can you adjust the settings?
Electronics Forum | Fri Oct 17 12:48:59 EDT 2014 | cyber_wolf
The only reason you would need to run this calibration is if the camera was replaced or the centering camera got whacked which is highly unlikely. If your placements are off, put an offset in the parameter file.
Electronics Forum | Thu Oct 19 14:20:18 EDT 2006 | sliebl
Something that I find unusual in some of the replies is the fact that local fids that are randomly dropped around the quad don't do anything for assisting the alignment of said quad. The only way that I am aware of the local fids being useful is if t
Electronics Forum | Wed Jul 31 07:51:31 EDT 2019 | ameenullakhan
Hi Dave, lead is 80Pb/20Sn. Top joint off CCGA lead is SN63/Pb37. Thermocouple was placed at center lead of the CCGA and one at the corner lead of CCGA. Ramp Rate Center 1.09 Corner 1.26 Soak ( 140 - 160 deg C ) Center 37sec Corner 38sec Ref
Electronics Forum | Tue Oct 20 11:37:38 EDT 1998 | Stefan Witte
All SM machines pick components with a vacuum nozzle. Most likely the component is picked in the geometric center, which may not be the center of gravity ( SOT 23, SO 89 ). Any other pick position than the center may be taught upon requirement, but y
Electronics Forum | Tue Feb 07 09:54:25 EST 2017 | rgduval
Are you having any issues with other ERJ series resistors from Panasonic? Any other 2010 resistors? There is, very likely, something specific to this part/package/packaging that is causing your problems. Things to check: -Identify where the issue
Electronics Forum | Tue Nov 14 14:26:28 EST 2000 | Francois
First groupe of questions: Is your machine have one head with multiple nozzles? Do you have separate vacuum tubes for each nozzle? Do you have problem with the same package or with all pakages. In your PNP machine, what are the dimensions tolerances