Electronics Forum | Sun Apr 05 00:23:53 EDT 2020 | researchmfg
1. To protect the nickel and copper under gold plating from oxidization before soldering. Gold plating can extend the PCB self-life and improve the solderability for 2nd re-flow. 2. Provide a good bonding strength. For Chip on Board process that Gol
Electronics Forum | Thu Dec 17 18:08:41 EST 2009 | lynn_norman
Back in a former life, we had 3 products that were PCBs bonded to aluminum boards. We used a PSA from 3M to bond the board to the aluminum. Polymers are almost invisible in x-ray, but ultrasound worked quite well. You should try CSAM. Don't know
Electronics Forum | Tue Oct 24 22:36:29 EDT 2000 | DL
On the main page of Smtnet towards the end of the opening paragraph states the following...Your " research continues in determining the reliability of thick film hybrid microcircuits and similar technologies using low-temperature, co-fired ceramics.
Electronics Forum | Fri Sep 27 11:20:21 EDT 2002 | davef
Mar, The previous post makes the best point. Your finish spec depends on the COB process you plan to use. Is your process: * Gold wire bond * Aluminum wire bond * Flip chip * Er, watt
Electronics Forum | Thu Mar 04 10:21:55 EST 1999 | Igmar
Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just a rec
Electronics Forum | Mon Sep 17 08:40:04 EDT 2001 | dave_bond
I have done a search of the Forum and didn't really see what I was looking for. We could be doing a 12" x 10" x .060" single sided ceramic PCB with all surface mount devices. Are there any "secerts" or "things to watch out for" when processing cerami
Electronics Forum | Tue Jun 17 01:27:25 EDT 2003 | Dreamsniper
Hi Guys, I need your opinion here. Has anyone tried doing this Process: Bottomside Process first which means gluing the chip components then reflowing the Glue instead of Curing them, then Topside process which is solder paste printing then compone
Electronics Forum | Thu Sep 10 09:47:15 EDT 1998 | Earl Moon
| hi, | 1206 capacitor with silver/palladium termination is mounted onto a ceramics substrates. Bonding is achieved through conductive epoxy. | We discovered that the epoxy cracked and this caused missing capacitor. We had tried different grade of e
Electronics Forum | Thu Feb 19 07:17:35 EST 2009 | mdavister
When I had to order ceramic (AL2O3, BeO, AlN) in the past, the fabricator always used a CO2 laser system for cutting holes and irregularities in the ceramic. Some companies that I have used that do ceramic cutting are: http://www.altinc.com/ http:/
Electronics Forum | Fri Jun 19 15:30:45 EDT 1998 | Tim Mattson
I'm hoping someone out there can let me know who manufactures ceramic PCBs or boards made of another material that can withstand 400C for an extented period of time. The board is approximately 8"x16". Thanks!
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830